Oops I added an extra 0, CNC router chamfer at 8000mm/m (315IPM)

[@BreakingTaps]

At least it wasn't the depth-of-cut that had the typo! :)

[@daan3298]

Well apparently you have been feeding way too slow then :)

[@VHERSACNC]

lol. Well it worked. how was the surface finish like?

[@NikitaLab]

Fuck I uploaded the wrong clip lol, made one with a photo of the finished part. Anyways it was much nicer than expected, just chip lines no chatter at all. I also offset the tip a lot more so the cutting diameter was larger, that most certainly helped a lot.

[@Tchefter]

Rock'n'Roll :)) Works fine :)

[@julienle9169]

Great video!

[@andrewbeaton3302]

Anyone else immediately check your videos speed settings??! Lol

[@keezo1234]

What ballscrew spec are you using on this machine? 1620?

[@NikitaLab]

1605

[@xillianto]

hehe, nice speed atleast ;)

[@tinayoga8844]

I don't like it. It made the video too short. ;)