Orphek Leds | 36" Blue Plus

[@philippemontjoie4900]

Hello thank you for the vidéo. Where are you buy the replacement bar please. Thank you.

[@niagarafirecorals]

Direct from a Orphek dealer

[@philippemontjoie4900]

@@niagarafirecorals Thank you. I find the other but not for OR3. May be send a mail to the customer ? Sorry for my english.

[@niagarafirecorals]

@@philippemontjoie4900 I had to contact them through email

[@stephenmichaluk5892]

What was the response time out of Orphek on replacement parts? I have 2 Dead Blue Plus 150’s. I reached out but no response.

[@niagarafirecorals]

Very quick response 👌

[@stephenmichaluk5892]

Lucky you. It’s been over a week and nothing.

[@niagarafirecorals]

@@stephenmichaluk5892 are you located in Canada?

[@stephenmichaluk5892]

Yes. I’m Calgary. Local vendor won’t bring in the 150 bars due to shipping cost.

[@niagarafirecorals]

@@stephenmichaluk5892 Contact A1 Aqua that's who looked after me.

[@LeslieOrphek]

Please note the thermal paste in this video is not enough a blob needs to be applied behind each diode on the board before putting it into the aluminum channel.

[@niagarafirecorals]

Good suggestion. I guess I could have added a little more thermal paste into the rail before adding the LED bar back in.. There was, however, still a substantial amount of thermal paste in the LED rail prior to putting it back in, hence the reason I didn't add more. Knock on wood. The rail still going strong today.

[@slipknot231000]

How much was the replacement bar ?? thanks

[@slipknot231000]

That dried up residue that's on aluminum bar is thermal paste you should have put new on

[@niagarafirecorals]

The replacement was $20 plus shipping. The total cost to my front door was slightly under $50. I'm aware it's thermal paste, and it was by no means dried up. Believe me, I got it all over myself. I didn't have any on hand. However, there was still more than enough that I was not to worried about it.

[@darrylchase3688]

I really can't believe the sloppy soldering work on the old LEDs. I see excess flux everywhere, not to mention the older tech LEDs they used.