OUTBOARD'S & A PAIN IN THE REAR

[@VernonTate-y1i]

My wife helped me swap out the rear end on 1979 Grand Prix when I was much younger she did a good job helping me yeah they are a pain great show see you in the next one 👍🏻🤘🏻

[@ralphbarker7791]

I enjoy seeing those scenes around the island. You are very lucky indeed to get all those outboards given to you as well. Another interesting vid, and great job on the van project too.

[@danielrobert7181]

That Astro van seems to have dealt pretty well with Kodiak's ever salty environment. Being a 4 -wheeler, if I'm not mistaken, just adds to it's appeal. I run a short shaft 1992 Johnson on a 16 footer aluminium hull. It always starts on 1st (easy) pull.and runs smooth and sweet. Great engine !

[@OutBoardTink62]

Wow you get great gifts for Christmas.!..

[@andywyeth1239]

Love it. Outboards and chevy astros .I'm in the UK and working on my Outboard. And chevy astro to.😊

[@leepatton1180]

You did great on the free motors

[@johntapley8527]

Thanks Mr super outboard man.

[@seriksson9721]

12.25 minutes. I totally agree with you, 2% is the minimum. Nice engines.

[@wendellholmes523]

I have an 88 15 hp Suzuki DT that has the charge coil in it for charging the batteries, works great.

[@victorremick9721]

Well that was different and enjoyable

[@jato1243]

As TOO says “If you have good compression, the rest is a pain in the azz “lol

[@robertchapin3683]

By driving that, does that make you an Astronaut? I have severe arthritis and I had to retrofit to electric start for my 85 or 86 35 Evinrude. Luckily, my flywheel was for electric start and I just needed to find the starter motor and the mounting bracket. I have learned a lot from watching your videos. I was searching for information on the retrofit and stumbled across your videos and have been watching ever since, thanks!

[@bryanmorrion9503]

Man in you’re part of the world a shower every couple of months would be enough. Looks really cold there and you say it’s summer. Here in Australia i think 15 degrees C is freezing 😜👍🦘🇦🇺

[@bennyblanko3]

I need your help. I was messing with my friend's 1975 4.5 hp mercury, and tried starting it with my impact with the cover/hood off and stripped the nylon lock nut on top of the flywheel. I can't tell online which is the right one to order (says @6?) Can I just go to the hardware store and buy a regular locknut? I measured thread pitch, and I don't think it was normal "fine" or "coarse". Also, I know ... too much, but ... I need a thumb screw too, as his was bent and stripped. I'm not sure which one/part number. It isn't the same as the later 8.5's and 15 hp (bigger diameter, and aluminum). It is about the same size as a johnson 9.9, but has a little finer threads. Thanks!

[@vandos11]

Hey KODI I have 1986 evinrude 15hp thats driving me crazy I have installed new intake gaskets new exhaust cover gaskets new head gasket and new powerhead bottom gasket and a power pack idles like a champ at slow speeds runs like a new one but when you give the throttle only making 7 or 8 mph on 14ft aluminum I can't figure this out do you have any ideas PLEASE ?

[@vandos11]

swapped the foot with another just to be safe still no change

[@TimsWorkshopTJY]

This was different to watch

[@billyotoole-o1u]

u need ta stupa clean dat astro automoooooobeeeeeeeel