Overhauling of auxiliary engine H.T cooling water pump

[@rejoymakil201]

U r working in heaven,mine is leaking it takes almost a day to do this job in my engine.

[@s1ned722]

Very nice, closed type bearing is heated in oil👍

[@TechnicalSailor]

Yes

[@s1ned722]

Yes, i see, this is not right, all lubricant that inside will leak out

[@danhtho.nguyen8465]

@@s1ned722 I think that you can put bearings on the top of boiler

[@jinxinzhao9372]

very good ,the music is also very good,

[@koleturner9148]

I suggest removing tell tale pipe. Can block up over time and if remains blocked and your mechanical seal fails, water will pass back through your oil seal into your oil system. Keep tell tale hole clear all the time

[@koleturner9148]

Also never spray a mechanical seal face with anything. Or touch it with dirty hands at the least

[@owermars3334]

@@koleturner9148 can you explain what is tell tale pipe?

[@arjunv266]

2e will be like photo keech photo keech😂😂

[@highseas9119]

should have shown the water draining procedure too

[@michaolczak6016]

Hi,nice job:) Did you measure the radial clearance?

[@olegspetrovs4823]

What about water draining? Is it required, or enough shut off fw inlet outlet valves?

[@shanper1]

drain first

[@anisulislam5030]

Upload a vedio how to take auxilary engine crankweb defelction

[@шеряковАлексей]

Thx😊

[@makara3646]

Rame amat yg ngerjain

[@SanjayKumar-eo7xy]

I face the problem in the same pump not giving sufficient pressure

[@СашаДимитриенко-д2ъ]

What is the liquid that you are heating ballbearing inside it ???

[@TechnicalSailor]

Lube oil

[@jayaselalupelautindonesia4681]

thaks this video 👍👍

[@SanjayKumar-eo7xy]

I have one more problem in same type of engine thermostat not operating regularly.

[@iamdevendrarajput]

Nice

[@SanjayKumar-eo7xy]

If possible can you send me yanmar same engine water flow diagram .

[@shanper1]

wrong way of fixing shaft with bearing to housing. Never tap inner race but outer using a bigger diameter pipe.

[@greglechowski5030]

You may be correct but that bearing may be a tight fit to the shaft and not the housing. They may have been actually installing the bearing properly.

[@stamatiosgavriilidis]

May cadet do an overhaul?

[@vazup2299]

Terrible ball bearing installing

[@thewolfpack9237]

Hello dear friend. The pump just next to the H.T that you overhauled is what? L.T? And whats the difference ? Where can i find and read the differencies.. Thanks a lot nice video though 👍

[@TechnicalSailor]

Both are same Centrifugal pump.Difference is only the temperatures of the water they are handling..

[@thewolfpack9237]

@@TechnicalSailor thanks

[@TechnicalSailor]

Ur wlcm

[@TechnicalSailor]

Plz share videos with ur friends.

[@thewolfpack9237]

@@TechnicalSailor i would like to see a video about all 3rd engineer operation routine and all responcibilities he has. Tell also about oil record book how we handle it and what exactly we write in . Thank you i already shared with some friends

[@alexlukwago3070]

Nice