Here we replace a dpf pressure sensor on this insignia car
Пікірлер: 23
@richardmounfield78222 жыл бұрын
Thanks for posting this vid. Just had a zafira at work with same engine, same code replaced sensor and couldnt shift the code ( SnapOn Triton ) with our diag tool . Went and borrowed an Autel off local garage . 10 min later done the relearn jobs a good un .
@Anthonyhowardmc Жыл бұрын
How much did it cost ?
@KawasakiVersys-bt8cc9 ай бұрын
Bravo mister O'Reyley for my Astra 2.0 cdti 160 hp 210000 km😊
@TheLightMyFire Жыл бұрын
I have the same problem but in the live data i have all the values good,0 at idle and if rev it it goes up ,voltage is the same at around 0.40 so the sensor is reading i did the re learn but i still have the error code and i doesent do regeneration at all ive done thounsands of km still no regeneration.
@the_retired_mechanic2 жыл бұрын
If you graph the live data pid you can quite often see the spikes on the graph that shouldn't be there as you rev the engine.
@jazzam80122 жыл бұрын
great job mate have you got a link to buy the sensor
@redouanemanaa Жыл бұрын
Does a faulty DPF differential pressure makes throttle position full opened at idle?
@paris34788 ай бұрын
Salut.as tu fais un apprentissage au nouveau capteur ou pas?
@cliffg497510 ай бұрын
Could I ask your advice? 2012 insignia 2.0 diesel if I take the rubber pipe off the sensor the car runs, when I put it back on the car won't run. What do you think it is? Thanks
@denisshera89948 күн бұрын
I have the same problem did you fix your problem ?
@grahamdunning2942 жыл бұрын
Hey another great job ..hey nice scanner .what sort is it ..
@ORileysAutos2 жыл бұрын
Hi. It's Autel DS808
@thomasobrien54112 жыл бұрын
@@ORileysAutos another great video, would you recommend this scanner for a small garage doing light eng service work and fault finding
@ORileysAutos2 жыл бұрын
@@thomasobrien5411 100 percent.
@afterburner399910 ай бұрын
Cracked Rubber Tube from Turbo 3 inches Wide
@sholze2 жыл бұрын
Good afternoon. I have a Peugeot Traveler. Error P2453 appeared. I was at the service, the differential pressure sensor was replaced with a new one. The error remained. the particulate filter has been cleaned. When diagnosing with the ignition on, the error is not removed. When the engine is started, the error is removed, but once it is turned off and started, it appears again. Tell me what is the reason?
@ORileysAutos2 жыл бұрын
Is there voltage at the plug? Is there sensor movement on live data? Was the sensor adaption done after fitting
@afterburner39992 жыл бұрын
kzbin.info/www/bejne/eYPKk3isjLGcgpo could be this
@joshsewell44702 жыл бұрын
Did you have to program the new one? Mine has gone I replaced it still same Issue and same error after replacing
@bojidarmartinov5949 Жыл бұрын
He litteraly programmed it in the video
@jessicajones424911 ай бұрын
Just replaced ours but was still limp mode took it to garage and basically reset it and now its fine... didnt know that had to be done was racking my brains
@Tahsin_Hussain10 ай бұрын
I think you did a WRONG JOB. You did not have to change the DPF sensor. Sensor was fine. The problem was, driver not running the car in motorway, so sooth accumulated. You just needed to do STATIC DPF REGENERATION. It will solve the problem 100% Same code P2453 appeared in my Vauxhall insignia and went into limp mode. Only running at 20 mph even when accelator 100% down. Then i did DPF Static Regen with Autel MK808BT Pro. Some Blue smoke came out. Then the fault code gone and Car back to nornal, driving in full speed. DO I STILL NEED TO CHANGE THE DPF SENSOR? I already bought DPF sensor from ebay from Good dealer. Is there anyway to check if they have send me a Good sensor or Faulty sensor? How do i test a new DPF sensor?