Paano mg wire | Temperature Controller XH-W3001 | para sa Incubator | Local Electrician

[@edtvchannel3731]

Very informative. Good job sir.

[@LocalElectricianPH]

Salamat po

[@arielcunanan4994]

Nice tutorial bossing

[@LocalElectricianPH]

Salamat po Sir

[@Tutorial_Ref_Aircon_more]

ok na ok..

[@LocalElectricianPH]

Thank you po.

[@mattworld2814]

Ok salamat Sir

[@LocalElectricianPH]

Salamat dn po

[@rogeliobaguio6768]

Boss may itatanong Sana ako.ilang ilaw ang kailangan para kompleto

[@LocalElectricianPH]

Dependi po sa design nyo sir. Basta maabot nya ang temperature na gustos nyo po. Or sa prescribe temp

[@rogeliobaguio6768]

Salamat boss lage Kong inaabangan mga video mo.watching from KSA

[@LocalElectricianPH]

Salamat Sir. Stay Safe Po.

[@ChristianAndrewEstrada]

Kahit anung klaseng wire ba gamitin jn boss?

[@LocalElectricianPH]

Gamit ka ng #14 po thhn or 2.0mm²

[@benjaminresurrecion4888]

Sir pano ntin yan e konek sa circuit board pra mg off at on ung burner ntin?

[@LocalElectricianPH]

Gamitan nyo po ng relay tpus signal nya doon sa ngpapa sindi ng burner..either solinoid po ba gami nyo Sir?

[@boyaxmixVlog]

Master hanggang ilang degrees maximum temperature nyan..

[@LocalElectricianPH]

110 degrees C po

[@benjaminresurrecion4888]

Sir aabot ba yan ng 75c at san natin mabili...

[@LocalElectricianPH]

Kaya po..dito ko nabili shope.ee/10YTUW2tNi