Part 1 - 1964 -1966 Chevy C10 DIY Convert Manual to Power Window Regulator

Part 1 of 3 1964 -1966 Chevy C10 DIY Manual Regulator Convert to Power Window Regulator
It's possible this may work from 1960 - 1966
Check out the forum for updates on the project:
67-72chevytrucks.com/vboard/sh...

[@Veryrandy8508]

I am have trouble finding those part numbers can you help me with this confusion

[@poduck2]

I'm wondering how difficult that gear is to find a replacement for, and if it is removable.

[@adrianperte5196]

Would you happen to have all the part numbers # for this kit please , oh and also where you purchased them ? . I’d love to do the same install ! Thank you much !

[@ojcasas]

I'm trying this on my 62c10. the motor works great on the bench. However when I install it the window will go up just a little bit. goes down with no problem. Any suggestions what could be going on? regulators and all weatherstripping in new.

[@VanGentFamily]

It is likely that the spring is not on or it is on backwards.

[@ojcasas]

@@VanGentFamily I tried it with & w/out the spring. Had the same results. I'll check if the spring is on backwards. thanks

[@chancock5005]

hey I have a 69 c10 im wanting to do this conversion on. how much difference do you think this would be compared to the 66

[@abejimeneza67c10]

Chad Hancock did u find out if it will it work on the 67- 72 C10?

[@garyrobins7375]

Sorry but I found this bad because of the camera being to far away to actually see what and where you cut. Also as a deaf person that wears two hearing aids, I couldn't hear nothing. Because I couldn't see your face to read lips.