Part 23 : Making bird feet and legs for competition

Showing how to use copper wire and solder for creating feet and legs for the bird. Adding flux to the joints and then using a butane torch to melt the solder. After the joints were completely soldered, a bur and stone (carbon silicate) are used to mark the ribbing and clean upthe excess nsolder. All the copper should be cleaned with emery cloth or sand paper before soldering. The back tendon should be much smaller than the wire used for the leg or toes. If you have any questions about the process or the products,please contact me through the comments section of this video or by email.
[e-mail]

[@todddudley3600]

Thanks for sharing this information there is not much out there on this.

[@rauschercarvingsandsupplies]

Glad it was helpful!

[@martymays8459]

Thank you for this video! Straight forward and basic with no complications! Nice feet by the way!

[@rauschercarvingsandsupplies]

Thanks for the nice comments

[@davidellul803]

Feet I struggle with,your way simplified it. Thanks Frank

[@rauschercarvingsandsupplies]

I am hoping to teach everybody as much as I know. That doesn’t say much. Try to learn as much from everybody who my help you in developing your own stye

[@kenedgerly6473]

Great video!! Thank you for showing how to do feet. Looking forward to giving this a try.

[@rauschercarvingsandsupplies]

Really glad you enjoyed the video. I had a request to show how to create the whole foot . Thanks for your nice comments

[@MerrylBustin]

Great video! Easy to follow instruction, well done! Going to try that method for sure. Thanks!

[@rauschercarvingsandsupplies]

I hope you will enjoy the rest of the videos and thanks for the nice comments

[@miguelchimelis5991]

Gbu what company made the machine that you used to polish those legs. I have one but is 3/32 is difficult to find the burrel i want one 1/8 I'm sorry for my inglish tank you ❤️‍🔥

[@rauschercarvingsandsupplies]

Not sure what you mean by polishing the feet or the bit I used. Can you describe it a little better. Thanks

[@miguelchimelis5991]

@@rauschercarvingsandsupplies I have 102 strong motor the machine is 204 strong 2.35 shank but I check again today and I found the 2.35 it's the same 0.093 I buy one set today let se I like you job I like art I se something less try if I kent do it tank you for answer my question ❓ God bless you 👍

[@miguelchimelis5991]

I'm sorry I told you the I found the part but they sent the wrong one I need the bits the you use to cut rotor machine.You send me the name of the store but I kent found the name that you sent me I'm sorry to annoy you thanks God bless you 👍