A series of installation videos for the Outback Flat Patio - with Cooldek
Пікірлер: 15
@packyh822023 күн бұрын
I just notice under the sheet. There's downlights, how do you run cabling for those downlights? Look like the foam sandwiched between the sheets.
@bigd387 Жыл бұрын
Is this the same process if it’s freestanding? Would both ends be cut back? Thanks
@Drew-hy6zr Жыл бұрын
These guys need a Milwaukee rivet gun. Iv had mine for 5 years as a stainless steel fabricator and never had any issue with 3/16 stainless rivets
@unclejuls58363 жыл бұрын
How would you install Downlights in this ? Would you have to do it simultaneously with erecting the awning ?
@stratcoAU3 жыл бұрын
Hi Yea, this video will show how to install the downlights into Cooldek - kzbin.info/www/bejne/rZvLomevj7Kib8k
@Moondoggy19417 ай бұрын
You think they would put wood stringers on the inside so you can get a place to put a screw into.
@barratthassett2 жыл бұрын
do you have to cut the sheet before bending the ends?
@stratcoAU2 жыл бұрын
Yes, the sheet generally needs to be cut as well as a blade may need to be run between the top sheet and the foam to create some separation to make it easier to turn the sheet up.
@hamidnasir83532 жыл бұрын
how much this roof will cost for 20 feet long and 12 feet pergola? Roof only with all installations?
@stratcoAU2 жыл бұрын
Hi Hamid, pleaes request a free quote at www.stratco.com.au/forms/request-a-quote and our design team will work with you to provide a free 3D design and quote.
@statanhelier9685Ай бұрын
How long does it take for polystyrene to decompose. I've used this twice. Also look in the video at the polystyrene blowing all over the joint. How do you get away with the polution. Both times I've used it what a mess. It looks like it has snowed. And why don't you cut the gutter part off in the factory. It's it because of laziness or money. I will never ever use this product again. Polluters of the 21st century. Disgusting. Shamefull.
@stratcoAUАй бұрын
Good afternoon, this product can be ordered with the edges cut. This should have been specified at the time of ordering. Thank you.
@gscribbs11574 ай бұрын
This is definatley not clear enough to actually do this job. Very poor effort by Stratco.
@stratcoAU3 ай бұрын
Thank you for your feedback, we are currently looking at updating our videos.
@morningsideable2 ай бұрын
If that wasn't clear enough you should get an installer maybe.?