Part two of Installing the Drake AC4R power supply upgrade

In this second part, we'll install the pcb, wire it in and test for operation.

[@charleswells9682]

Sir, I have just finished installation of the AC4R in my power supply. While I was in the Navy, I did not spend 50 years in the communications field (I was a Machinists Mate) your excellent video, along with the good instructions, enabled me to easily build and install the kit. Thank you very much for making the kit and the videos available. I do have 2 minor comments: the installation of the PCB may more easily be done by attaching the ell-brackets to the PCB and then mounting it onto the transformer bolts, and the bolts used to attach the PCB to the brackets could stand to be 1/16" - 1/8" longer than supplied. Again, thank you very much for the kit, the instructions and the videos. I would send a picture, but it is all buttoned up and reinstalled in the MS4 cabinet. Now to finish the R-4A and T-4X recap and on to the fun. 73 Chas AD0UY

[@karlschwab6437]

Mike; this being your second KZbin video, both are fantastic and should sell a lot of your AC-4 power supply upgrade kits, at least for me! My only thought was, since there are no grommets were the new wires pass through the chassis, to perhaps, add a bit of "wire spaghetti" or heat shrink tubing to the area that passes through these holes.

[@jimsullivan755]

Thanks Mike. Jim - WB6TNF

[@seanlynch1841]

Do you happen to sell the power supply tester. I have so many AC-4s , that would be a nice thing to have around

[@theheathkitshop2424]

I don't sell the tester, but might have some of the pcbs left.

[@hamlive7923]

@@theheathkitshop2424 ok well I’d be interested in paying you for one if you’d be interested in making one some day. Great video btw