PC Power Supply Conversion to a Bench Supply

[@lmwlmw4468]

Great work.

[@johndelaney1606]

This is a great video - thank you. For years, I have taken power supplies an attempted to use them as a bench power supply. I never connected anything to anything other than the 12 volt. Each and every time, sometimes sooner than later, the power supply would just shut off. I would have to disconnect the power to the the power supply, wait a while and reconnect for them to reset. But, as always, they would shut off. So, I did not see/hear any mention of this problem with your set up here. PLEASE tell me how you got around this issue?

[@anonymousyoutuber7935]

The breakout boars should have been installed within the case and run wires to usb panel mount for a cleaner look

[@gregorytrenhed8318]

Really cool they have come out with quite a few new boards, I like yours but didn’t see it on Amazon, found close, do I ever need a 3d printer

[@johncrow5552]

where did you get that break out card?

[@doc1701]

I found all mine on eBay, TEMU and Aliexpress.

[@urbbs09]

What was the pc psu that you used ?

[@oturanboga6225]