Perfect Arrow Flight Part 2 Finding your Center

Part 2 of a 3 part bow tuning video series.
In this series, we are building a Doctor Ed Ashby 12 Factor (actually, 11 factor) arrow. Currently, we are addressing Factor 2... Perfect Arrow Flight.
In order to achieve perfect arrow flight, we must first back up to the "spring" that delivers the arrow to the target... the bow.
In this video, I will show you how to find your true center shot. Every manufacturer has a specific recommended setting. Following these recommendations ensures that you are getting the best performance from your bow, increasing speed, forgiveness, and accuracy. For bow hunters, momentum is going to be at it's best when the bow is set to these specifications.
Follow along as we set the arrow rest 13/16' from the riser, and straight through the center of the Berger Button hole found on all risers. We will also ensure the arrow is level from the bow, promoting efficiency and reducing drag. I will also demonstrate how to tie in nocking points and a D-loop.
Please reach out if you have any questions.
As always, please Like, Share, and Subscribe.
Resources
www.ashbybowhunting.org
www.bowhuntingsuccess.com
‪@RanchFairy‬

[@madman432000]

You could just screw that top nock point down a touch until it is right at the nock. You could have them tied really tight though. I like to tie in nock points with nock in place. It's a bit distracting when the cameras show flipped images, one camera shows a right hand bow and the other one shows a left hand bow.

[@PersonalBestOutdoors]

@madman432000 I appreciate the feedback! I am brand new to this videography stuff. I'll make sure to key that in mind in the future. My soft knots I not only tie tightly. I also put cool melt on the serving thread before tying them on there. Then put a sightly heated blade against them to allow the cool melt to do it's thing on my center serving. The result is a soft knot that you can still take off, but won't slide on you. I do use a nock for choosing where I'm going to tie my soft knots on. I showed this in my video. Thank you for watching. Happy hunting!

[@Verticalbowoutdoors]

You can almost fit two nocks between thos nock set knots that’s why it looks like you arrow is not level

[@PersonalBestOutdoors]

@@Verticalbowoutdoors thank you for the comment. Although it may look that way on camera, I can assure you that there is only about 1/8" of space between my nock and moving point. This gap has been perfect for me to ensure I don't get any nock pinch when at full draw. I plan to make a video on this. So many people have nock pinch without being aware. This can cause major tuning issues. The level of the bubble is also a camera angle thing. Plus, I was more worried about the "left to right" bubble location. Without that being perfectly centered, it can manipulate the true distance reading between the center of the arrow and the inside of the riser on the bow. Thank you so much for watching. Happy hunting!

[@Verticalbowoutdoors]

@@PersonalBestOutdoors I’m sure you’re right, it does look like a big gap on camera.

[@PersonalBestOutdoors]

@Verticalbowoutdoors I appreciate the feedback. I had to watch that section after your original comment. I'm figuring out the best way to get a good view with the camera. The feedback helps to to know how I can improve. So thank you. Happy hunting!