How to assemble engine VVT-i Toyota Part 10: Connecting rods bearing caps tightening

[@chandradatcoonauth7246]

Hi peter... can I change the connecting rod bearings on a 1nzfe engine under the car or do I have to take out the engine? If can do a video would be great.. or just give me some advice..

[@PeterFinnTheCarDoctor]

Noted 👍😊

[@freepalestine4049]

hi peter, can you teach me to tie all the bolts. thank you for the knowledge given..greetings from malaysia

[@PeterFinnTheCarDoctor]

Sure thing

[@waikosalua4261]

Very excellent job

[@PeterFinnTheCarDoctor]

Noted 👍

[@allantreyes4445]

Hi Peter, Do I have to apply thread locker to the rod bolts? Thanks

[@PeterFinnTheCarDoctor]

Thanks for comment 😀👍

[@MsOmaley]

Hello, I rebuild a 1 AZ-FE casting rod with a 1AZ-FSE. can you explain to me the marking on the connecting rods, example: 2 M B and 18. And can I put the FSE pistons in the FE? thank you very much for your videos.

[@PeterFinnTheCarDoctor]

Hi, I need to read books...

[@MsOmaley]

@@PeterFinnTheCarDoctorHi, I think the mark B is connecting rod small end bore diameter, it is a whole with the same mark : rod pin piston, and the mark 2 is connecting rod bearing size.

[@Jimmylee314]

Hi, is it the clearance between the condrod cap and the crank, have to be measure before tie the condrod screw with the touqe that given?

[@PeterFinnTheCarDoctor]

You are right, that clearance is good to measure too.

[@Jimmylee314]

Thanks for the advice..

[@vuyaniseabelo4285]

Peter, I have a problem on my side. I took my crankshaft for cutting and it was sized to 20000 for Main bearing and Big ends, when I replace it it rotate on the main bearing but when I put the big end bearing it does not rotate. help me out

[@عاشقالتفاحه]

peter you should tight main bearing first ,, to make shure its good,,, thanks peter

[@PeterFinnTheCarDoctor]

Hello and Thanks for your comment. :-)

[@sohailabdulghafoor8026]

Hello I have a question for you that. How can I judge that how much force should apply on bolt or how much should I tight the bolt Please answer me A weating of your reply THANKS

[@PeterFinnTheCarDoctor]

Every engine has own specific service book, where is all force amounts.