Pinball connector repair repin

[@kqp76t]

Thank you very much. Informative, straight to the point and well taught. I owe you one!

[@LeebosPinball]

Glad to help.

[@bvanleeuwen254]

Recently replaced the same connector and jack on my Banzai Run interconnect and replaced the connector with a heavy duty variant which functions the same but can handle more power going trough it then the regular ones. Just a few cents more expensive and worth it just to not have to remove the board again. Also a funny thing is that on the Banzai interconnect for my game they only populated every other pin like you did. And put special 0-ohm resistors to basically jumper the voltage to the traces on the next pin.

[@LeebosPinball]

Interesting. It sounds like the the board design changed over time (at least for Banzai) to handle the ‘every other pin’ connector design. Good to know.

[@bvanleeuwen254]

@@LeebosPinball Yes that is also what I think did happen, especially since Banzai had a different board from the very start. Might be interesting to check if any of the traces have holes in them that serve no purpose, I do not have access to any other interconnect games to very this at the moment

[@J-Sargent]

Thanks for the video, This helps alot

[@LeebosPinball]

Glad to help.