Thank you for this video. I had the issue with the probe that it was inside the plastic. Now my Bianca is fixed with no money spent!
@note2you3 жыл бұрын
thanks for share
@achitofernandez25703 жыл бұрын
I heard that the problem full boiler... is a usually problem in MaraX... few friends have the problem... the waranty change the machine
@ShalevAbuhatzeira Жыл бұрын
What is the PN for the Mara X / Bianca water level probe gasket which come somtimes in white or green foam metarial? I need to replace it in my bianca.
@lelitinsider2977 Жыл бұрын
teflon gasket (white) for the water level probe
@ShalevAbuhatzeira Жыл бұрын
@@lelitinsider2977 thanks. Which diameter and thikness?
@lelitinsider2977 Жыл бұрын
@@ShalevAbuhatzeira 13x17 h 2.5mm, or use some teflon tape, it works
@hariswiranata98943 жыл бұрын
My bianca only reach 2 bar and water debit from screen/head only flow out a bit. What is the problem?
@lelitinsider29773 жыл бұрын
there may be dirt in the flow control, contact your dealer or email care@lelit.com for more information.
@ekinnyc2 жыл бұрын
Is there a way to drain the steam boiler without turning the machine over? I had this issue, fixed by replacing the level sensor. Was fine, until I drained the service boiler by opening the hot water tap, then when I added new water, I have this problem again
@lelitinsider29772 жыл бұрын
hi, with bianca , if you drain the water from the water tap, you remove complitely the water, look the boiler inside kzbin.info/www/bejne/fmjImWVubtOInpY
@lelitinsider29772 жыл бұрын
how old is your machine? if you need help , to be faster please send a video at care@lelit.com
@pilosopo25 Жыл бұрын
Where can I buy that water level probe?
@lelitinsider2977 Жыл бұрын
from your reseller in your country! or ylu have to look for a reseller lelit