Plastic pipe fitting mould: a special 90° elbow injection mould.

[@jonjon3829]

thanks I was wondering how to do the inner wall in a 90° bent pipe. much appreciated

[@jigneshshah5239]

How do we balance wall.thickness of aricle when in old moukds core becomes off center by 0.5 mm ?

[@salmanattiq]

at 1:18 when yellow poll pulls the brown round slider, it came out after bending. My question is that when it will close again will it create problem by rotating itself or damage cavity block while closing please clear this

[@abdvillers9683]

The green stopper behind the yellow round bar will help push it to it's initial position you can see a round hole is provided till a certain distance which will help it, just need to be too sure and confident of the pin used to connect the yellow and horseshoe block that's still a concern

[@pradeepsaraswat5849]

Please see how the close slider like going forward

[@ernestoortega5673]

Es un buen diseño de molde

[@ricardooliveira288]

Uauuuu top this mold. Mechanical perfect. 👏👏👏👏👏👏👏👏👏

[@suryasuri659]

Can you do aluminum elbow in HPDC?

[@ramazanaydin6111]

gorgeous

[@vikaskumar9134]

Thanks

[@ringrosejayden225]

Great. Thanks you very much

[@dineshagrawal6711]

एन्डकेप 4 इन्ची 5 इन्ची बनाने के लिए मोल्डिंग मशीन+ पूरा सेट कितने रूपये में सेट हों सकता है सम्पूर्ण जानकारी चाहिए

[@حمودهعفرين-ض9ح]

شكران

[@radheshyamkumawat1148]

सर इस मशीन की रेट क्या है बताई जा सकती हैं

[@MekiaBeshir-ru7ny]

haw to communicate

[@dynotruck7094]

Which software do you use to do the animation of the mold components?

[@Snake60rus]

If we inspect triada view then that may be NX

[@malgaya]

Cost ?

[@ChinaMoiron]

PVC pipe fitting mould

[@mohammadsaboohi9434]

❤

[@ghassanghalebsukkarghali3477]

Sir, what is the start cost of this business

[@SparkMould]

Hi,Could you provide me with the specific needs of the pipe fitting mold? like 2D/3D Model or samples.I can provide you with an accurate quotation.Thanks whatsAPP/Skype :[phone]

[@radheshyamkumawat1148]

@@SparkMould prize