Plumbing For Water Table on DIY CNC Plasma Table | Filling Table WITHOUT A PUMP

Today I Finish up the Water table on my DIY CNC Plasma Table. I Install a shower drain and a plastic barrel to drain the water to and connect them with 1 1/4" PVC pipe. I also plumb in an air line to lift the water from the plastic barrel to the water table. draining the table takes a little while but filling takes less than 3 mins to fill 40 gallons.
One thing that I'd like to note is that the 2 fittings on this plastic barrel were different. with the way I have the plastic mounted the bottom fitting was 2" NPT and the top looked to be 2" 10 TPI. the barrel had a cap that screwed into the barrel that had a 3/4" NPT tap into the cap. I was surprised that both holes in this barrel were not 2" NPT.
Thank you for watching!
Music by:
All Lights Out - Molife
Now I'm All Yours (Instrumental Version) - spring gang
www.epidemicso...
The Off Road Corner is a participant in the Amazon Services LLC Associates Program, an affiliate advertising program designed to provide a means for sites to earn advertising fees by advertising and linking to amazon.com.
1300

[@Blou55]

Did you ever think to use a dimple die for the shower drain...

[@millairefpv6292]

Hi ... do you have a diagram or drawing for this water table system? Please thanks

[@Blou55]

Really nice and no pump...I'll make one like this for my next table.

[@GoatOffroad]

Looks absolutely awesome! Great job! Can’t wait for you to build my back bumper! 😂. ❤️🐞

[@TheOffRoadCorner]

Thanks bug! We’ll see how my bumper design works out. I may make my design into a builder kit you and boo could build haha

[@Dave-ue3yo]

Try the rubber gasket in the underside of the table, you will gain another 1/8 “

[@TheOffRoadCorner]

Good point I’ll try that

[@constructiontech1970]

Oh yea the rear bumper build!!!

[@danhambrick6331]

Nicely done.Was the John Deere the hint for your next video?

[@TheOffRoadCorner]

Haha nope. The steel plate I was stand in front of was. It wasn’t the great hint

[@jacoblam8225]

how's the barrel holding up has it collected any silt or debris