PNW Components: How to Install the Loam Lever Gen 2

[@zdravo4]

How small device made with a lot of attention to the smallest detail. Made with feedback from the riders. And lifetime warranty says it all, my Big respect for that! 👍❤️

[@scott5731]

Bike shop routed the cable under the screw not above it. Still works but should i change it

[@Intoccib]

I would like to see the installation of the i-spec mount as I have found this task to be impossible

[@jake730]

All Shimano I-Spec mounts (A,B,II,EV) are connected to the Loam Lever via a screw. As in a screw that goes threw the I-Spec mount and threads into the Loam Lever. Which part are you struggling with? Bike Radar and Shimano have detailed articles/guides explaining the differences and how to mount them you may want to check out.

[@gfxman14]

why does sram or shimano adapters matter for a dropper post? it's a post, not shifters or brakes...

[@JamesM-T]

Does the loam lever gen 2 22.2 mm fit the range bars?

[@objectuser]

OMG the end! 😂

[@sendyseth22]

What happens if I break my loam lever gen 1 somehow??

[@philbagus9662]

Hi there ✌️ is it possible to lock this dropper in intermediate position ? Or only full open/close ? Hope you understand my poor english 😂😂😂

[@jake730]

Yes, this is possible with almost every dropper post on the market. You will have to manually release the lever you are using to have the dropper stay in an intermediate position. There are no dropper levers on the market that will stop a dropper post halfway/intermediately.

[@MartinTeerly]

I have hope breaks. Why you don't make a mount for it ?? It's a deal breaker for me