Polaris General Heater Install 2016 - 2019

Polaris General Heater Installation
Polaris Part # 2881316
Check out the Products at www.lpequipment.com

[@jeffstefani5197]

Great Video, I'm getting ready to do this on my 2018 general 4 and i feel a lot better about it now

[@joshsigafoose]

Did this on my general 4 last weekend. I did the 2 1/2 hole saw for the lower vents and turned out great

[@JB-mi7nx]

it's easier to just bend up the engine heat deflector to get to the bleed screw. :)

[@jacknordberg2426]

Awesome video! Great job

[@2fast65]

Great video thanks have a great night be safe.

[@johnerickson2463]

Is it wise to have shut off valve to keep fluid from going through the heater when you do not want it to?

[@josephwhite8578]

Ive bled mine 20 times, it seems fine, but then overheats again. I added a heater....is it possible that it can take this many times? I've been at it for a full day

[@thedirtygeneral7220]

Very nice! I've thought about doing this to mine but I play in the mud to much.

[@jasonkellerman7534]

Why would playing in the mud keep you from doing this?

[@thedirtygeneral7220]

@@jasonkellerman7534 the main part of the heater would be under water/ mud a lot. Not sure how long it would take that kind of abuse so not worth spending the time and money on it. I could be 100% wrong.😁

[@firemt_9778]

Great video and thanks for sharing. My question is does the duct work have clamps to hold them into place on the vents or no? Thanks

[@tallyhooooo]

FirEmt_97 zip ties I believe. If not zip ties work just fine

[@firemt_9778]

tallyhooooo, TY

[@shawnnn3]

Question Is there a heater for the General 2021? Website please.. Thanks Good video

[@mikecoleman1092]

Yep- just installed mine today. After the install my machine was overheating and had no heat. I am in the process of using the bleeder valve, think i have a bunch of air that is limiting my heat. I didnt clamp the hoses like a dope so i lost a lot of coolant.

[@fupa74]

i have a 2019 with ride command, how hard is it to take out the RC screen?

[@kagerding]

How did your install go? I had to remove my subwoofer for my ride command system.

[@fupa74]

@@kagerding It was pretty easy, didn't have to take out the RC screen. One thing they didn't tell me is to elevate the front and have someone rev the motor and add coolant at the same time. I put in a inferno brand heater.