Precision Matthews PM-1440GT Lathe VFD

[@mrcpu9999]

wasn't obvious you were trying to sell it. I was thinking it was going to be a review. Got me once.

[@SnakeRiverRifleworks]

My apologies.

[@Franklinguy759]

So is my opinion of these made in Taiwan lathes “The cleanest dirty shirt “ accurate?

[@mholl618]

If you were starting over, would you just save the money from getting a manual lathe and just go straight to a TL-1 or ST?

[@SnakeRiverRifleworks]

Thanks for your comment! Hindsight, time and efficiency is the most valuable resource. I would have went strait to a CNC.

[@bluehornet6752]

I bet you sold this before the video was even uploaded, lol...

[@nicolebaker5193]

how can i do on my pm-1440gt auto shut off? any advice?

[@SnakeRiverRifleworks]

You would need to make a control cabinet with relays, magnetic sensors.

[@buckem03]

Did you get it sold?

[@SnakeRiverRifleworks]

I did.

[@benzam6218]

Why are you selling it?

[@SnakeRiverRifleworks]

We bought Haas TL1 and we needed to make some room for a Built American Equipmen Cerakote oven, spray booth, Eaton Air Compressor, and sand blasting cabinet. Home based 3 bay garage shop.

[@benzam6218]

Thanks! That makes me feel better! I just purchased a PM-1440GT, so I was worried you didn't like it or something. @@SnakeRiverRifleworks

[@troutfitter547]

Is it sold?

[@SnakeRiverRifleworks]

It is.