Рет қаралды 107,091
Edit:
That was my very first attempt to make a die set, it is far from perfect compared to what i make now, check my FB page for more info
I have also made my own and very unique press (Pocket Press), much cheaper, 15 times lighter than the presslug ! and have much cheaper die set also
-
* 42CrMo4 German steel for the inside chamber, heat treated to ~58 HRC
* 1mm exit hole
* Hard turning on a broken HSS tap (full hardness state)
* The needle was made out of a hard chrome shaft
* The male shaft was made out of high carbon steel (not treated to extend the lifetime of the inside chamber)
* Presslug original pressing footage was used as I did not make a suitable setup for the press
* The displayed slugs are the actual slugs made from the DIY dies