PRISM SUPPLY | DIY Install | PS-41 Tail Light & Fender Mounting Bracket + Chop Your Sportster Fender

[@colbybarron4300]

Absolutely a worth while purchase cleaned up the back end and only took an afternoon 🙌🏻

[@Roolis77]

You guys need a hot air fan for thermo covers 🤣... Love the stuff You do!!

[@ilovecarnitas]

hi guys. curious, do you know if the hole spacing on your bracket is same as those OEM bolt holes? have a paint job on it and hoping to not put new holes in.

[@remiallen6119]

Thanks for this! Just ordered a brake light and plate bracket from you guys, I'm going to chop the fender just like that. Is there a way to protect the fender from rust where it was cut? Besides doing a full paint job? Thanks!

[@PrismSupply]

Thanks for the support! There are a number of options you can go with. You could do a simple clear coat or an even easier route and use a paint pen or something along those lines. Hope that helps!

[@ilovecarnitas]

Tada! Cool vid. In case a viewer is wondering the license plate can be mounted below to the open holes.

[@nathanphillipson1457]

Hey guys could you do a video detailing how to use the single wire tail light magic box? Cheers

[@PrismSupply]

We're planning to soon!

[@pd1jdw630]

Would love to see how one would make a sportster into a small road king looking bagster with hard cases. But this looks cool.

[@ralfrainfurth6034]

Cool

[@LarsGalbraith]

Should use deutsche plug

[@Akendic01]

Can't you just buy iron 883 fender and replace it instead of going through all this?

[@danahill3103]

What sissy bar is that??

[@Pvt._Liquor]

That bracket looks sloppy with the unused bolt holes hanging off the edge.

[@PrismSupply]

They won't be unused when there is a license plate attached to them.