PRL Motorsports Cobra Cold Air Intake Unboxing and Install!

[@uhhh684]

Literally the best install vid

[@wrist6660]

i love this tutorial because a lot of the others ive seen always have unnecessary cuts

[@kevingebhard23]

I dont own a SI, but enjoyed your video. Always good to learn. Yes I own an R, PRL is the best.

[@kevingebhard23]

Yes I hate those clips, there tools that make it easier but are annoying. When I installed my Eventuri intake and PRL intercooler or anytime you take out the bumper. I really dislike it lol.

[@PRLMotorsports]

Thank you for this wonderfully detailed video. We're sorry to hear that you did not receive any clamps with your order. Feel free to reach out to us to resolve this issue if you haven't already! Hope you enjoy your intake! :)

[@mastachiefa2010]

Thank you so much for going into detail..this video helped me out so much.

[@xXReichstadXx]

Ex army? Air force? Waffle top

[@568501032]

Hi I’m stuck with a wire that is attached to the original bracket that I’m unable to detach could you help me out

[@DavidSchleifstein]

At 53:00, when you say that you want to make sure that the lip inside the large silicone pipe lines up with the lip on the rotoform: could you please clarify what you meant there? It seems like that large silicone piece can only really go on one way and still have it's top point in the appropriate direction to connect to the MAF, no?

[@AFBubbleChaser]

So inside the the hose there is a lip. The hose does only go on one way, however you need to make sure it is pushed down far enough to meet up with that lip otherwise you could have vacuum issues. Let me know if you need more help.

[@MrErick-zg9gj]

Good job on the vid. Where was this video before I installed mine? Lol. Took me awhile also with that airbox removal. I actually removed the aluminum lower engine cover to remove the airbox below vs going up.

[@mikejmardis]

You waisted your time taking the box apart. Work smarter not harder. FYI- when working in the eng bay, you should never need anything bigger than 1/4” tools. With the exception of exhaust components.

[@the_batmobile0.4]

Please do for Canadian model