Problem With The Rossi R92

[@jh5869]

What a blessing, Josh! I might have never found that little screw. I'll have to check how tight my screws are, and maybe treat with blue Loctite. Check Palo Verde Spring Kit for Rossi 92s. I bought one.

[@budman3890]

Just picked up a R92 .357/.38 last week. While doing a quick going over before shooting, I found several screws loose on the receiver. Check them over before taking them out to the range.

[@runningwithscissors3997]

Yo - reach out to the company. Had the same thing happen with a revolver yoke screw and they promptly sent a new one - no charge of course.

[@243Outdoors]

Yep. I may do that.

[@ga-gz1bo]

Those Rossi Rifles must be total garbage . I’ve never heard of so many problems from so many people…

[@Tex_I_Can]

It's running well now. Very fortunate to have found that tiny screw.

[@243Outdoors]

Yes I am. I had thought I dropped it or lost it. I was on hands and knees looking everywhere for it. Then thought to look outside and there it was.

[@Tex_I_Can]

@@243Outdoors Good for you! I would have been panicked.

[@georgiaboy4410]

Glad you found that screw. My rifle loves that Lee 158 RF👍🏻

[@243Outdoors]

Yes Sir. I was running low on them and casted up a few hundred a couple months ago. That's what I powdercoated last monday.

[@mcb2757]

just avoid rossi. buy a henry or a marlin if you want a lever gun.

[@cw2a]

Hello Josh! Ooh no! Glad ya figured it!!

[@243Outdoors]

Howdy CW. My first time into a lever gun. With some youtube video help, it's not that bad.

[@unclejim2330]

You’re not the only one with a screw loose. 😂🤭

[@243Outdoors]

At least we're not alone.

[@adonisdelacampa7057]

So this is a known issue huh? Should I just get a marlin

[@Billbobaker]

mine was hard to feed ammo without getting bit but a bit of polishing and it's now freaking amazing.

[@243Outdoors]

I had to work on the 45 colt a little but this 357 wasn't too bad.

[@jamespollard1670]

You're lucky to find that tiny screw . I would have lost it in the dirt .

[@243Outdoors]

I though I had lost it in the basement and I had only worked on it on the table. Then realized I never took that one out. Went outside and there it was. Lucky me.

[@BOHEMIANHUNTINGCLUB]

Good deal on finding the screw. 👍🍻

[@tonyp2632]

Your sights seem to be lined up fine. The best sight alignment I could get was 4 inches high and 3 inches to the left. So for now I have a red dot on mine. I wanted to keep the old school look but I also want to hit what im aiming at. Other than that, love it.

[@gunsnwater2668]

Good deal finding the parts. I like the Rossi 92 ranch hands.

[@gimpy1017]

Bad company to get warranty done or even hear back from them

[@CrankyCleatus]

Nice Josh 👍