Profile 14mm Rear Mini Hub Assembly

Profile's Gus Lanzilotta walks you through a complete build on a Rear Profile 14mm Mini Hub (same application applies to a Profile Elite and Madera V-2 Hub).
We hope this helps.

[@muffemod]

No lubrication on the pawls?!

[@juliangaribay4711]

Btw is there a difference between the ti driver and normal chromoly driver I know the weight but what are the pros and cons

[@justinfleming800]

the ti driver is stronger so therefore it wont wear out as quick

[@RideOrDiee]

Do u guys put any grease or lube on the driver or you install them in the hub dry?

[@ProfileRacingOfficial]

No grease! Clear lube (like 3 in one oil) can be applied to the pawl pockets. Dry is fine too!

[@maricelbonto3479]

What's that press called?

[@juliangaribay4711]

No grease to install bearings on the shell it kinda made me uncomfortable

[@MrFuchew]

its the right way

[@michaeldebusk113]

How should I go about replacing the driver bearings?

[@ProfileRacingOfficial]

Peep the FAQ and Tech section on our website for more help!

[@noelcampbell6411]

Profile Racing I did but my hub isn’t behaving the way the guide indicates - when I hammer the axle as directed, the far bearing refuses to come out. I see no deformities and everything until that step worked. It says you shouldn’t have bang too hard. Well, I definitely am hitting it harder than I’m comfortable with many times. Any tips for troubleshooting this?

[@assholedestroyer4207]

Can you switch these hubs from rhd too lhd

[@stazz4130]

no,,

[@yannd.8256]

So is it now ready to use? No grease/oil needed?

[@ProfileRacingOfficial]

Yes, but a few drops of tri-flow or a LIGHT oil can help though!

[@crazy8boy145]

Profile Racing So when you have to take the axle out though do you use a rubber mallet on the drive side or non drive side? Please let me know

[@ProfileRacingOfficial]

@@crazy8boy145 It depends on how you disassemble it, but we would hit it from the NON-drive side.

[@crazy8boy145]

Profile Racing Thank you guys for the response

[@muffemod]

aluminum 14mm nuts?!

[@ruztmetal]

Does profile mini driver fit in to the cult match v2? I'm currious.

[@cleettaurus8637]

Why would it 🤡