Programming an ATV212 Drive to Run Using PID Control | Schneider Electric Support

[@САМСАМЫЧ-у5ж]

With the help of the parameter increase the frequency?

[@ВасяСемёнов-у6и]

good! thx

[@ВасяСемёнов-у6и]

nice

[@MrVitaliyAT]

How to "go sleep" and "get-up"? I am doing: TYP=3 F201=20 F360=1 FMOD=3 F633=18 F644=4 THR = 78.8 LL = 26 F391 = 2 F256= 30 F393 = 33.8 AND 33,6 as target I have 1.6MPa manometr and my target is 5 Atmospheres After this I on motor. Manometr physically locked - always show 4mA. It work on 26 (do not even try up Hz) by 30sec and go to LStp ("sleep"). After that never get-up.

[@MrVitaliyAT]

Plus SW100 = I

[@vaidasmikalajunas5323]

Please show how you spin the motor, because your setup does not work. The only way how we got to work PID - use VIA for setpoint...

[@lgninjalo]

It isn't just you. I think this video is wrong. I'm actually dealing with some of these set up like that and that HMI set point is maxing out the frequency rather than using a percent of the analog signal.