Pulling The Rear Suspension Off My Sonett | SAAB Project Pt 25

[@uriel5708]

You already strip em all thats dedication right there 🎉🎉🎉

[@gafrers]

Those internal lines really are "square peg in a round hole" case Great work as always

[@Ludicrous_Speedway]

Couldn't have said it better myself, aside from cursing at it that is :) Whenever I get around to it I think my plan is to have the two hard lines from the floor dead end into a distribution block with soft lines going to the, well other soft lines but the external ones. Even though I don't see myself fiddling with those brake lines too often I don't like them and I want to make my own. Those sheet metal dimples are also really sharp. Thanks for sticking around Gafrers, it's always fun seeing where else I can find you on YT.

[@gafrers]

@@Ludicrous_Speedway Nice Plan.

[@GT1900garage]

Thanks for the episode. Is there any episode/ time stamp to see the rollbar problem?

[@Ludicrous_Speedway]

Not yet. It'll get featured as a side project in a later episode. The problem is it's just so difficult to get to the fasteners that hold the roll bar on. After a few hours of split knuckles, I was able to get them loose enough that I could slip a hacksaw blade under the roll bar and just cut it off. I'm currently drilling out the last bolt stuck in there. Thanks for sticking around!