Pulse Motor Running Bigger Loads On Same Input Power!!

VCR Modified Pulse Motor running from a power supply feeding 12.00 volts x 0.47 amps = 5.64 watts charging a 1 x 40 volts 68000uf capacitor literally takes minutes to charge at full capacity and charging 1 x Ultracapacitor 2.7 volts 350 farads which takes 17 minutes to charge at 2.5 volts running a 100 watt scooter motor performing at ruffly give or take 30 percent efficiency displaying sufficient amount of torque while the charge/discharge rate continues to remain stable ongoingly in absence of using any boost converters or controllers.
Modifications were made by adding another pick up coil in series, re wounded driver coils with more turns, added another MOSFET in parallel, changed a resistor to a higher value and adjusting the duty cycle/frequency. There's more improvement to be made.

[@windpowerandmore6310]

Ha that's sweet! What do you think about it so far? You did a amazing job with that build!

[@11Sam11]

I'm having a lot of fun with this driver circuit design. It's pretty awesome. Waiting for a balancing board to arrive so can connect those 5 x 2.7 volts 350 farad to beef it up even more along with the idea i mention on the description and see what this baby can do. She's got balls that's for sure :)

[@windpowerandmore6310]

@@11Sam11 Makes me happy to see how good of a job you're doing that's pretty impressive

[@11Sam11]

@@windpowerandmore6310 Thanks man. Much appreciated :)

[@dinoalic9700]

Unreal mate! Well done 💪🏻💪🏻