Alignment: ANSI Centrifugal Pump

[@rhubert2539]

Helpful and not over technical for us newbies!!

[@skunkjobb]

The six o'clock position seems hard to measure with that type of indicator stand but there are others that are more flexible.

[@AlphatecEngineering]

interesting video! thanks for sharing it.

[@javeedhvactechnician7760]

kzbin.info/www/bejne/gmfJqmd4hKaqhJo

[@Ninjagurl13]

Very helpful, thank you!

[@javeedhvactechnician7760]

kzbin.info/www/bejne/gmfJqmd4hKaqhJo

[@nguyenwindy1600]

Pls help to compare shaft alignment method ( rotate 01 shaft vs rotate 02 shafts)

[@xejaisonjj]

Can you elaborate more , on how to fix the mis alignment if its horizontally

[@skunkjobb]

Move the motor. The bolt holes are often so much larger than the bolts so you can push the motor a few mm sideways.

[@derricke01ify]

why would you move both shafts together to measure parellel alignment? wouldnt you gauge from 3 to 9 only moving the shaft with the dail indicator attached to it?

[@theofficial9190]

Yo do this because if you have coupling runout either shaft you will read the runout along with the misalignment

[@javeedhvactechnician7760]

kzbin.info/www/bejne/gmfJqmd4hKaqhJo

[@stavk6983]

The keyway tolerance could be slightly offset for the shaft coupler as well. In theory, you should have a tight fitting coupler but working on "brand used" stuff when the budget is tight could play a factor. But if the stock market is ok, go on and buy you them fancy keys and what not. The divit on a used key can really be make the coupler sit funny.

[@strongspear7315]

Fantastic

[@MaterialManagement1]

Can you tell me, which kind of coupling are you using?

[@ThexGreatxLTS]

Sure-Flex 6J one-piece sleeve type coupling

[@hishammosa6977]

How mach the tolerance

[@timmartin8563]

Ummmm , not to sure the laser alignment will turn out well..... seeing has how the laser head is on backwards AND even if it were facing mirror the mirror goes on movable side !!!!!!!! Oooooops

[@nikoekaarisma205]

Is good❤

[@shah0125]

We literally use Allen key to do the alignment

[@brettwilliams3471]

That works well

[@litocudia871]

Reverse alignment need

[@javeedhvactechnician7760]

kzbin.info/www/bejne/gmfJqmd4hKaqhJo