Quick performance 9 inch rear end differential assembly. Trac lok posi #posi #quickperformance #gbody #differential #montecarlo
Пікірлер: 24
@terryhunter25262 жыл бұрын
Hey dude the big hole in the axle hub is where you tighten up your t-bolts for your retaining ring that holds your axle in and your brake plate on
@lw91252 жыл бұрын
Thanks for taking your time and sharing. Much appreciated.
@redneckswitwheels9 ай бұрын
Your video is why I ordered my 82 gbody cutlass 9 in rear. I was goin to use a grand national 8.5 but... I guess I will put that in my el. So thanks for putting this video up !!
@carsntrucks7829 ай бұрын
You’re welcome It’s been great so far.
@8004dodgers Жыл бұрын
Nice diff. Would like to have a rear-disk brake one myself but their hella pricey $$$
@carsntrucks782 Жыл бұрын
Definitely worth it the original is weak
@Se7enthsonSS Жыл бұрын
It’s $20 extra for 11in disc brakes
@jasonlackey6122 ай бұрын
Do you have a link for the parts you ordered?
@jermaineknowles872 жыл бұрын
Got one in a cutlass on my channel
@Se7enthsonSS Жыл бұрын
Ok stupid question. What’s the fitting for that is located on top of housing on axle tubing?
@carsntrucks782 Жыл бұрын
That’s just a breather vent
@Se7enthsonSS Жыл бұрын
@@carsntrucks782 ok thank you!
@glennglass17362 жыл бұрын
Is this a stock rear housing width and if so what is it or it’s has been shortened from quick performance thanks I really appreciate and what was axles length on the videos as well
@carsntrucks7822 жыл бұрын
It comes as a kit quick performance builds it from scratch to fit the g body perfectly
@Macnificent78_11 ай бұрын
When the spline don't line up do you have to take the center section off
@carsntrucks78211 ай бұрын
No u just take the axle and spin it as hard as you can and stop abruptly
@carsntrucks78211 ай бұрын
Or spin the axle in the opposite direction as fast as you can if that doesn’t work
@mrhitthat132 жыл бұрын
Did it not come with the two different bearing retainer plates
@carsntrucks7822 жыл бұрын
It came with the ones you see in the video that’s it.
@heshtesh Жыл бұрын
@@carsntrucks782 My kit is the same as yours for my Sonoma. I also have the drums.
@Se7enthsonSS Жыл бұрын
Did you need a new driveshaft going to a 9in?
@carsntrucks782 Жыл бұрын
No just needed different bolts and the part that holds the u joint I have a video showing the exact parts and bolts I used form autozone or advanced.