QuickJack SLX7000 Unboxing and Setup!

Hey guys welcome back to my channel, I hope you enjoyed this video, or maybe got some use out of it, I’m going to be doing a review on the jack in a couple of weeks after we use it a few times.
Check out my SC300 Instagram here: ...
Also make sure to Like and Subscribe if you are new to the channel, and also comment down below any suggestions or ideas that you have for me and the channel!

[@sidnum]

Did you go through the bleed procedure before lifting?

[@Cole.sc3]

No we did not.

[@StephenHerbetko]

Hello, I just purchase my quickjack 7000 and am missing a lot of parts. It looks like you guys are also missing the “valve stems” did you fill the air cylinders with 50 psi? Also did you bleed the air out of the fluid lines?

[@Cole.sc3]

According to the quick jack representative said was that the jack did not need to be filled with the 50psi to lift, and we did not bleed the air out of the fluid lines either because they said that was not needed.

[@Cole.sc3]

But they did send valve stems and we are going to fill the air cylinders soon, but we used the Jack just find and did an install already and it worked great! (New video coming soon!)

[@StephenHerbetko]

Gotcha! I am also missing the 2 power unit fittings. Hopefully customer service sorts everything out!

[@Cole.sc3]

@@StephenHerbetko okay, well yeah those were the only things we were missing, but yeah I bet they will send you those fittings. 👍🏽

[@kaitabad]

How long did it take to get yours after you ordered it?

[@Cole.sc3]

It took about a week and a half to get here!

[@kaitabad]

@@Cole.sc3 thanks