Radio System: Dual Path Setup & Wireless Switch (Receiver Redundancy)

[@MrVoice1]

This is the best tutorial i have come across so far...many youtubers pretend to teach you something and hide most of the process...big up to women, then do better than men when comes to details...

[@jodecuyper7495]

Hi Jeti team Thanks for the many extremely useful video tutorials. Really helpful. I have a technical question about dual path and receiver voltage alarms. I have a large scale model. I have installed double path with a REX10 as primary, a REX3 as secondary and a 900Mhz II as additional backup. My radio is DS-16 II. Everything works fine just as advertised. I have telemetry displayed so I can monitor all three radios, voltage and antenna strength. All fine. Now here is the thing: after switching everything on, my receiver voltages all show 7.8 volts (which is the BEC output from my kontronik cosmic). All good. But after some minutes sitting on the bench with no inputs, the receiver voltage on the secondary receiver drops down as low as 6.5Volts. To be precise: this is the minimum value for the secondary receiver as displayed under the actual value which continually shows a healthy 7.7volt. It appears as so there is a glitch in the telemetry reading of the receiver voltage or the voltage drops for a very brief moment to 6.5 quickly returning to 7.7Volts. Problem is that this momentary dip triggers the alarm on the receiver voltage and that is kind of worrying because it is not clear if this alarm should be taken seriously or if the threshold should be lowered. Exactly the same happens when the receivers are on battery power. In fact I use a JETI DSM Esc dual switch with a magnetic switch to route the BEC from the ESC and the receiver battery in parallel. I dit not detect any malfunctioning in the model itself, even if the servos are loaded and the receiver voltages drop somewhat. They never reach the low end of 6.5 as displayed in the telemetry. Sorry for the long question but better be safe than sorry ... So I look forward to your advice. J. Decuyper (Belgium)

[@RTD1947]

Outstanding video

[@alexanderzawydiwski9534]

Is it possible to control electronics on one receiver with the sticks but when you flip a switch it’ll switch over to the other receiver because I’m building a Robot platform with a arm but I can’t figure out a way to use one controller to switch between both receivers

[@accessor100]

i would like to watch one video like this for exemple 120cc setup with 2 servos each wing and 2 servos in rudder and 1 servo each elevator, and how can i do kniofe edge mix and another mix, because looks like complicated them another brands ,, and how use 900mhz antenna because i have DS24

[@EspritTech]

Hello Thelmo, please email [e-mail] for technical answers. Thank you.

[@tanajisuryawanshi984]

What is price

[@thebikingdad782]

do you need the central box for the switich to work to power the model on and off

[@EspritTech]

Hello Adam, please email [e-mail] for technical answers. Thank you.