S550 Hexacopter Drone Build with Pixhawk 2.4.8 Flight Controller | Complete Walkthrough

[@randomexperiment9165]

Flight test?????

[@novisfpv]

hello, thank you for this wonderful tutorial . Q: How change motor spin direction without swapping motor wires?

[@AirtimeAerial]

If everything is already soldered, you may need to correct spin orientation in the param settings for whatever type multirotor you've built..quad, hex, octa etc etc. I'm new in the build arena myself, and motor mapping is def a tricky phase sometimes from what I've experienced. I also think that diff esc's have diff adjustability as well, so maybe you can get away with a re-flash of the esc's? Wish I could be of more help, but from one learner to another good luck with your build and hope it works out for you soon! 🙌🎉

[@ericrchobbies1610]

Nice 👌

[@karmayogi5531]

Hi, I am also making a S550 hexacopter using pixhawk 2.4.8. I am using a R9MX OTA receiver and X9D plus 2019 Taranis transmitter. I am able to spin my motors using pwm channels of receiver but when i am connecting the receivers SBUS out port with the RCin pin of pixhawk the motors are not spinning. When i am switching my transmitter on and it connects with the receiver, the pixhawk is showing an error sound like it is in your video at 36:48 minutes. Can you please help me with this? How can I contact you?

[@RakishRc]

@@karmayogi5531 hi, so are you sure the signal wire on receiver is on sbus out and not subs in? Secondly the signal wire on rc in Port of pixhawk is connected to the bottom pin and middle being power and top being ground so the order of wire is correct? When you hear the alarm sound do you see the error message on mission planner hud screen? If the above steps are correct then it's mostly like the sbus protocol for receiver is not set correctly in radio. Do you see channels active in receiver menu of mission planner?

[@karmayogi5531]

@@RakishRc yes, whatever you said, I have done all these things correctly. I am able to arm the drone but motors are spinning automatically, i am not able to control the motor speed using transmitter throttle stick. I have calibrated the radio transmitter again and all the channel bars are moving...this means pixhawk is receiving the SBUS signal from transmitter through receiver. I think there is some settings I need to do in mission or in transmitter to take control of the flight controller. Can you give me your whatsapp no. or any email id?

[@RakishRc]

@@karmayogi5531 have you mapped the channels correctly in mixer page of the radio settings? You can contact me at telegram @rakish33

[@karmayogi5531]

@@RakishRc yes...i think so....ch 1- Ail, ch2-Ele, ch3- thr, ch4- Rud.....

[@RakishRc]

@@karmayogi5531 send you pictures and mission planner screenshot on telegram will get it working for you

[@rajkamat6989]

What is size of anti vibration pad

[@ipshort1851]

Total cost how much?

[@kojiodo3371]

Hello! If I have any questions, where's the best place to reach you?

[@shashikantgaikwad5797]

Where can I purchase this complete kit

[@vitaliydyehtyarov2584]

Hi, Thank you for the video, this is probably only available video instruction how to assemble this drone. Can you please make video or at leas diagram how to conect 2 and 3 axis gimble to the controler?

[@rajkamat6989]

Where to buy anti vibration pads