RAM 2500 Cummins DTC: P0934 Line Pressure sensor Circuit Low

Follow all manufacturers' official instructions and safety procedures. Attempt ar your own risk.

[@OCmeiwaku]

amazing video.... every important detail was covered ... including the probe 5v test... many thanks !!

[@PremiumFuelOnly]

@@OCmeiwaku Glad it helped!

[@jameswinkelman5341]

replaced my tranny with and autozone reman...everything great til p0934 came on..i have been trying to figure this out for months. tried several non oem parts...finally took it to a shop...said the pcm was bad wanted $2000 to replace...did it myself--code came back...wish i would have seen this before this mess started...just ordered an oem...thanks for the video..i know electrical parts can be sensitive but this is crazy...hopefully this is it

[@PremiumFuelOnly]

@@jameswinkelman5341 Yea, if you tested the wire harness and replaced the PCM, it's likely the sensor.

[@christopherblanco380]

It's been a month now, has the P0934 come back? Dealing with same issue P0934. Thanks for taking the time to make this video.

[@PremiumFuelOnly]

Just made a 350 mile trip, no issues.

[@gabrielsalazar6648]

I change my valve body and screw broke and I didn’t think noting of it since it was only 1 .but now I’m getting 2 codes Po933-hydraulic pressure sensor range performance P0868- transmission fluid pressure. Can the bolt be the cause

[@PremiumFuelOnly]

Not sure but usually that error is the sensor is bad.

[@gabrielsalazar6648]

@ sorry I mean my valve body screws broke .u think that could be the reason for the code

[@PremiumFuelOnly]

@@gabrielsalazar6648 No, the sensor code is very specific.

[@Zage55]

thanks man i installed a reman transmission from autozone on a 04 5.7 1500 and it came with a new sensor which is most likely not oem so i hope installing the dealer one fixes this code and also i have a question it also has a p1775 can you lmk what could cause that

[@PremiumFuelOnly]

Sounds like a solenoid is stuck, hard to say without pulling everything apart.

[@handtohandcombat3535]

Replaced mine and the check light came back on after 100 miles or so. But this time the truck shifts perfect.

[@PremiumFuelOnly]

Was it a dealership sensor?

[@handtohandcombat3535]

Nope, looks like that's the issue.

[@christopherblanco380]

I replaced mine, and now I have new code, P0869 Line Pressure High. 🤷‍♂️

[@PremiumFuelOnly]

Was it a dealership sensor?