RAM REBEL AMBER DRL PROGRAMMING *HOW TO GUIDE*

Detailed guide on how to change your DRL Locations on your Ram 1500 DT via ALFA OBD
Items Required For this Video Can Be Purchased On
www.weekndgara...
Instagram: @weekndgarage
Email: [e-mail]

[@singhgill3735]

Thats what i was looking for. Can u make video abt mirrors folding and unfolding when u press lock and unlock on key ? Thx

[@bruce88wayne]

Not bad. I opted for Tazer instead. This seems to do the trick too, though.

[@WeekndGarage]

Tazer once you unplug it, you lose all tazer functions until you plug it back in, also this doesn't take up the OBD port onboard. Both works tho

[@SpartanFitnessPro]

What are you running for exhaust? Sounds badass!

[@WeekndGarage]

Thankyou! its a Flowmaster 717915 Remote Valved Exhaust

[@remigielis]

Thx brother, I love it how turned out

[@WeekndGarage]

Any time brother!

[@remigielis]

@@WeekndGarage btw I have my secondary “funcart” fiat 500 abarth, do you have any light mods on it? Since app is made for FCs…

[@WeekndGarage]

@@remigielis Haven’t tried directly on the fiat 500, you can play around with the settings make sure you backup the original profile before making changes

[@gabrielbadimvilela]

I saw that u r using the AlfaOBD to code, but which OBD Bluetooth conector r u using to pair with the app?

[@jafigueroa4728]

Awesome. I have a 2019 Ram 1500. The Halo bottom left light is out. How can I fix it or can I turn them off. I would prefer to fix it. Thanks

[@tjbecker9592]

Is there an app that works for IOS? My Bluetooth won’t connect to V-Link on IOS.

[@chuckbilly907]

great video. Is this only for the led light package or the halogen too?

[@KarbonSym]

Does that program have the Dodge Charger in it? In the 23 Charger the DRLs turn amber to signal a turn and I want to run them in Amber constantly as DRL

[@WeekndGarage]

Yep does the 23 charger as well, same back end BCM

[@Livinlife2]

How do you enable fog lights with just the white halo? If I set drl to no. It gives white halos. Should I change drl Location to fog lights and then enable drl again?

[@MrJazz8469]

Once programming is finished, are the 2 connectors to be reconnected to their original terminal and Alfa OBD and connector to be removed?

[@patrick012182]

From my experience, removing the OBD is fine, but removing the harness caused an error

[@allontario]

How do you make the halo amber, I did it a While ago on a TRX and I can't figure it out for the life of me

[@RekonRC]

Can you add program the bed lights with this?

[@Egosuppressor]

Can I do that to a lower trim halogen headlights? I got 2021 Bighorn

[@Thepirloagas]

What app do you use for ios?

[@jg4u2call]

Nice. Which programmer is it? Where can I get it?

[@ayyy9017]

Will you be able to drive with the drl off?

[@carlosperez-jt3wb]

I am technologically challenged/disabled so please help. Which of the many OBD apps do download into my iphone ?? Thanks

[@WeekndGarage]

This app is only on Android devices not on iPhone

[@zellcarl]

great Vid ,thanks. can you change programing to fold in mirrors in when parked

[@aclass9830]

Yes

[@MrJazz8469]

Where can I buy this alfa obd and the bypass connector. Can I call you, I’m from Vancouver…

[@WeekndGarage]

Send me an email [e-mail]

[@MrJazz8469]

@@WeekndGarage I sent you an email dated 17 and 18 July 2022 respectively. For info I already bought the OBD and connector and android pad as well and both the app, only programming is remaining. If I can call you or call me is better. Thanks

[@karldence2549]

Do you have a link for the alpha obd?

[@randyknafel5951]

Do you install the plugs back in module when you get your programming done?

[@dieselfred8084]

Yes

[@tpaz4]

Do you know what the difference between “optional DRL” and “no DRL” is?

[@WeekndGarage]

Optional follows the programming on the DRL location setting. No DRL is no DRL at all

[@taresch0310]

When I followed the Steps the Amber Lights will g o on for about 1 second and then shut off immediatly... any idea? I put it on optional and turn signal..

[@WeekndGarage]

When the engine is on or when it’s in just Ignition on mode?

[@taresch0310]

When the engine is then started@@WeekndGarage

[@billys4446]

Do you know if this works on all models of ram 5th gen trucks ? I currently have the Hemi 1500 bighorn with aftermarket lighting

[@MSchumacherfan]

I did the same change with JScan on my 2020 but the drl only shows when in motion

[@neho_itme]

I have limited ram 2500 it will work?

[@MrJeduardoc7]

Do you know for mirror running lights?

[@313tfd]

It may be in the comments, but can you change the halo to amber?

[@WeekndGarage]

You could change the DRL to the turn signal, if you wana turn the whole halo to amber you gotta swap out the actual LED board in the headlight housing

[@denmark219]

What does DRL stand for?

[@WeekndGarage]

Daytime running light!

[@fredA1234]

Where do I buy the programmer?

[@dieselfred8084]

It's just a app on playstore

[@fredA1234]

Thank you but What I meant was the OBD connector that was plugged into the cable. The cable was listed, but not the OBD connector.

[@christopherbriceno7434]

Will this work on a 2019 ram rebel ?

[@WeekndGarage]

Yep it sure will

[@singhgill3735]

Any one knows what configuration to change. When u lock truck i want mirrors to fold and when unlock they should open

[@TheOlds350rocket]

Buy a tazer

[@shutkibbles1749]

Do you have a link to the dongle so I can buy this?

[@WeekndGarage]

Just added to the video description!

[@renehalaiko8081]

Where do I buy the dongle

[@torredcat4395]

Can you do just the amber without the white halo’s?

[@WeekndGarage]

Not sure about to completely turning them off but you can definitely dim the white halos down to 1/4th of the brightness

[@RobertBambach]

@@WeekndGarage Can your make the white halo DRLs brighter than factory setting? mine always seem barley noticeable during the day. is factory value like 1/2 brightness or is it already at 100% default ?

[@apkhatri]

Do you think you could find a way to keep the puddle lights on or the approach lights

[@WeekndGarage]

While driving?

[@donniejackson6045]

What’s the back look like??

[@WeekndGarage]

Back of the truck?

[@donniejackson6045]

@@WeekndGarage yes I was just wondering if having the amber lights on up front kicked em on in the back?

[@WeekndGarage]

@@donniejackson6045 This programming only affects the daytime running lights located in the headlights. No change in the rear of vehicle 🚗

[@donniejackson6045]

@@WeekndGarage thanks

[@BWLightGuy]

Still working on it

[@WeekndGarage]

I think you may of missed a step, because the demo vehicle is a 2020 Rebel mate

[@BWLightGuy]

@@WeekndGarage i appreciate the response! I'll have to try it again! It keeps saying that the vehicle is already set with the turn signals as the drl. But it's not. I'll try again! Thank you!

[@BWLightGuy]

Turns out I didn't go in to settings on the infotainment center and turn the DRLs on. It worked! Thanks for being patient !

[@J2010Kramer]

I followed the steps and nothing is changing....

[@WeekndGarage]

Power cycle ignition, you can only see the drls when the engine is on, there also has to be enough ambient light so the truck thinks it’s a sunny day

[@J2010Kramer]

​@WeekndGarage my white signature lights have always been my DLR's. But when following these steps and selecting the turn signals as DLR the white lights are still the only ones on...

[@WeekndGarage]

Try restarting the procedure it definitely works for ram DT models, you have the SGW bypass plugged in?

[@J2010Kramer]

​@@WeekndGaragesilly me. I had DRL turned off in the radio menu. Now my question is, can make so just me amber lights are my DRL and have the white lights off?

[@WeekndGarage]

@@J2010Kramer Check out my video called how to turn off Halos DRL Ram 1500

[@hassannady-hl2kn]

Hi

[@hassannady-hl2kn]

I need to switch off the low beam while driving it’s automatic as soon as you hit gear selection to drive does there anyway to turn it off without switching off headlights auto feature?

[@WeekndGarage]

Hi yep that’s what this video just explained

[@hassannady-hl2kn]

@@WeekndGarage hi I don’t think it solved What I want is to keep the hailo light working as DRL without the indicator lights but when I did that and switched lights switch to auto nothing happen and all lights were on low beam and DRL

[@hassannady-hl2kn]

When light button set on automatic it should be as follows At day light it should be the DRL only and night should be DRL and low beam but unfortunately I couldn’t do that

[@hassannady-hl2kn]

@@WeekndGarage I really appreciate your response

[@terryreedy107]

Can you program sequential blinkers with Alpha ODB?