RB26 FULL ENGINE BUILD: Episode 16 - Setting Camshaft Degree & Timing Belt Tension

Welcome to episode 16! In this episode Colton dives into setting the tension of the timing belt, as well as all the steps to properly set the degrees if the intake and exhaust camshaft according to the Kelford specs.
www.boostfactory.ca // Instagram: @boost.factory

[@myg240z]

It's always nice when your ATI damper can be used as a degree wheel. Once again, great content guys!

[@JamezAdam]

Cam degree seems to be a little painstaking

[@boost.factory]

yes it can be a bit lengthy, alternative method... adjust on dyno, if adds power good, if not remove!

[@UltFrizz]

Japanese engine, American measurements. Very confusing

[@boost.factory]

Unfortunately, we are taught imperial and meteic here. And I speak in imperial in the industry out here!

[@A1N9D8I8]

Info: good Mic: bad

[@boost.factory]

Oh we know.... mic location sweater pocket = never again!!