RCBS Bullet Sizer

[@deadhorse3389]

WOW This is fantastic modification, well done! I would like to see more on exactly how some of these mods were made.

[@Histandard2011]

Sold the unit quite a while back, however will give you a little information on what I did. First took some 4" thin wall square tubing and made a riser about 6" tall to house the heater. I heater was a 150 wall light bulb. The bottom of the tube was bolted to a bench and then using a plate that was welded on to p of the riser I bolted the sizer. The light bulb with in through a hole in the back of the riser. I then used the thermostat from a 120 volt hot water heater to control the temperature to the sizer. The next thing was replacing the manual pressurization that came with the press. I have a small home machine shop so I got some replacement parts from RCBS and then constructed an air cylinder to force the heated lube down and through the dies. I am sure you could purchase an air cylinder from a surplus store and save yourself a ton of work. When all of this was done there way no you tube so I had no reason to record all the build process. Thanks for watching the video.