How to Install Go Rhino Dominator D6 Side Steps on 2022 Tundra

[@donvape336]

I'll tell you this. I have these for the 4runner with the frame mount. It takes three hands to mount the rails. I used a large washer to hold the joiner up so I could start the bolts. START IN THE MIDDLE. You'll thank me later. It took me 1.5 hours for the sliders after I figured out what to do.

[@RolandoMota-w2u]

How do you like them? Thinking bout getting same ones for my 4Runner

[@Seba12GA]

@@RolandoMota-w2u 10 of 10, very good product ;)

[@jkuoverland8507]

Why not 4 brackets per side? Can extras be ordered. I’m 6’6” 250#, seems to have a good amount of flex if I step quickly? Thanks

[@mach5jeep]

You Midwest/Rust belt guys shouldn't forget the anti-sieze compound on the bolts.

[@rubengarcia7265]

Should have showed more angle views when installed👎

[@Wilsoncraft.studio]

Far easier to loosely attach the mounting brackets to the board first. Move the brackets approx to where the mounting bolt holes are under the rockers. Lay down under the vehicle and pull the board over you with the brackets positioned next to the mounting holes. Push the bar with brackets up to the mounting holes, loosely thread the nuts on the middle bracket. Then slide over to the front and then the rear. Then go back and and tighten things up. Only way to do these by yourself lol.