In this video I do a bit of wiring to convert the crossflow loom to pinto spec with electronic dizzy, and talk about how to successfully (and not) fit a type 9 box into a standard tunnelled Mk2.
Пікірлер: 20
@evo53493 жыл бұрын
Nice reminds me went I built mine and started with a mint shell and a expensive paint job in two pack venetian red and full chocolate brown RS 2000 fishnets etc, and 2.1 pinto on twin 40s and rolltop Bilstein sprung for night events but the car turned out so nice I didn't rally it.
@rkerr99924 жыл бұрын
Going to be a beauty when she’s finished Kris your doing a great job
@Legnum6664 жыл бұрын
Small wire black section is a fusible link. It’s designed to heat and break if there is an issue. Need to replace it with new one or a fuse not sure what rating it would be , looks good, good work, :)
@ronsre-creations52894 жыл бұрын
Hi Kris, from across the pond.... Doing nice work on that escort. Thumbs up ! Looks great !
@AliMackMechanical4 жыл бұрын
Man i hate wiring. But your getting there buddy. We all need wee reminders lol. 👍 spot on man.
@CrashValleyCustoms4 жыл бұрын
The one small wire at the end is a fuseable link, it will melt like a fuse if there's a short circuit, I had one fuse on a mk1 fiesta once, the alternator wire had touched the exhaust and melted, 😉👍
Keen to see the x-pack again Kris, stay safe mate.
@stefankaz534 жыл бұрын
Careful you don't scratch the edge of the wing, with those wires.
@AndrewSandilands-tk6st4 жыл бұрын
Blimey, looks like you could do with some shelving there to organise your parts lol
@AndrewSandilands-tk6st4 жыл бұрын
Oh plenty of KZbin videos on the way with that lot then 👌 lol
@SkylarkCamperAdventures4 жыл бұрын
Better just replacing the black bit of cable and replace the whole length back to the joint with decent red. If it was being kept as absolute standard I could understand.
@Legnum6664 жыл бұрын
Sorry, just seen the other comments!, should have read them first lol! :)