Recreating Creatbot (Electronics)

[@dukezillo]

can you share the BOM ?? or a you are planning to share a guide of all this mods, i would like to apply to the printer of the office

[@Cjsairgunscarsandmachining]

I don’t have a bill of materials, this isn’t a build like that, this is all custom, I decided on things last minute, change things if you read the comments through the video you’ll see that I change things many many times, even what’s in the video isn’t all what’s there now, I kept a lot of what’s there it’s most of it, but again the comments say all of this. I don’t have a list like that, I ordered so many different things. I wouldn’t even know where to start. I’ve tried seven different MCU boards, and configured every single one, I’ve tried so many different of every single part different motors, different drivers different power supplies, different everything wiring everything, but what you see in the video is what I did end up using in the end for pretty much everything except the external 5160 drivers on the electronics and the external power supply, I increase the size to supply power for heat, and then I changed it on the motion system new motors, new belts, new hot end, new carriage, it just went on and on for months