Redcat Lowriders LR6X Controller Stick Dead Zone Fix

[@liquidwhat]

Supper helpful videos.

[@Balakay9435]

Hell Yeah Brother 🇺🇸🦅

[@baezn88]

My 59 does the same. Thanks for the vid.

[@NorthSideCustomRC]

No problem 👍

[@timlopez7352]

Thanks brother

[@itzdakidink]

Would any of this work on the 63 ??🤔🤔

[@lambo485]

thanks:)

[@yungfatalkain27]

How did you swap the front switches with the rear?

[@RCLowriderConnect]

🎉🎉🎉🎉🎉🎉🎉🎉🎉🎉

[@NA5TY_RC]

I tried this with my 59 and I still have play in channel 5.

[@NorthSideCustomRC]

This fix really only applies to chan 3 and 4 where Redcat programmed the hop switch to not operate chan 4 without a mix active It's something else if it's chan 5 but I might be able to figure it out. First thing would be to check if any mix settings are connected to chan 5 and turned on, unless custom there should be no active mix on chan 5

[@NA5TY_RC]

@@NorthSideCustomRCyea I tried exactly that. Every how you explained it with channel 5 and 6.

[@NorthSideCustomRC]

​​​@@NA5TY_RC5 and 6 it will have no effect. This is a fix for how Redcat programmed the left side switch different from the right side switch This is specifically for chan 3 and 4 because Redcat programing in the transmitter requiring a mix to link chan 4 to the hop switch Chan 5 and 6 are both programmed to the hop switch, not requiring a mix to link the 2 on the switch You should have no active mix on chan 5 or 6. It does not need a mix to run on the hop switches. Look in your mix, in any of the mix are set to chan 5 or 6 turned on. Turn them off, the cha 5 and 6 switch do not need a mix.