Humidification | Dehumidification | Desalination | Process Performance | Matlab | Simulink Model

This is a performance model of the Humidification Dehumidification Desalination Process. Water Heated Humidification dehumidification (WH-HDH) process is used for producing fresh water from saline water at sub-boiling temperatures. This process uses a low-temperature source such as solar energy or waste heat source. Although these heat sources are available with minimal operating costs, an optimum thermal design is required to maximize the water production rate for given heat input. In this work, the main design and performance parameters are investigated for two HDH cycles namely, water-heated and air-heated cycles. First-law based thermal analyses are provided and performance charts are presented by considering assumptions. The system contains the following:
1-Humidifier.
2-Dehumidifier
3-Heat source.
Users can control the heat source to get the results of the amount of productivity that should be produced.
• Humidification | Dehum...
**MatLab-SimuLink should be used to run the model.
Copyright © 2007 by Mohamed A. Sharaf Eldean Ayoub
Model download link:
www.redslibrar...
REDS online shop:
www.redslibrar...
Facebook:
/ redslibrary

[@farukkilic6010]

wonderful

[@yousefal-enezi9613]

السلام عليكم استاذي انا عندي اسايمنت في نفس الموضوع ممكن اتواصل معاك لان عندي مجموعة اسئلة اذا تقدر تفيدني لو تكرمت ويعطيك العافيه على الشرح الجميل

[@ehabmanharawy415]

الله ينور يادكتور. I am building a model on excel for a natural draft tower that operates on a variety of sustainable energy sources. I did the solar heating in a coil in the beginning then had to abandon the idea due to pressure losses. My other approach now is to is to heat up the tower via solar energy by using dark metal plates installed on the tower surface on metal rods that are connected to a metal packing inside on which the contact between saltwater n air occurs. The plates are be vaccum insulated from ambient air. So I am now stuck with the thermo dynamics inside the tower. Should I simulate it as just heat input? But that wouldn’t allow me to size the surface area of the packing or the geometry at all. Can your model help me with this configuration or it’s not in the scope?

[@mohmadali193]

دكتور اقدر اتواصل معاك عندي مشروع تخرج عن نفس الموضوعً

[@mohammedabdelwahabsharafel2515]

You can via website chat www.redslibrary.com

[@REDSLibrary]

Visit my chat through the website