Reloading 101: Brass Prep. Brass Prep for .223 and 5.56-start to finish

[@garyjohns4711]

using southern shine stainless steal chips eliminates having to check for stuck pins....

[@EverydayReloadingandShooting]

@@garyjohns4711 but will they get into the primer pockets? If so, sounds like an excellent choice. thank you for the input

[@2pugman]

I have the original FART machine and I only run it for 90 minutes, max. I don't use any SS pins. It's not necessary.

[@garyjohns4711]

@@EverydayReloadingandShooting they will actually pass through the flash holes

[@EverydayReloadingandShooting]

I find that the stainless steel pins get inside of the primer pocket as well as inside of the case to clean out all of the carbon. That's why I use them. I have tumbled with and without and I think tumbling with them does a better job. But to each his own.

[@peteregger7928]

Looks like you knew the wife was going to be gone for awhile?

[@EverydayReloadingandShooting]

Ha ha. She actually came and had to clean off the counters while I was running the water from my brass. I said nobody's going to care. But she said I care. She puts up with a lot of crap from me frankly.

[@peteregger7928]

@@EverydayReloadingandShooting My wife is a keeper too!

[@EverydayReloadingandShooting]

You're blessed man!