Remote Control Your Lighting with the GrandMA3 Web Remote

[@thenateman6969]

The answer to the questions I have on my list. Definitely have gotten a lot from Event Lighting tutorials! Thank you

[@Event-Lighting]

🙏🙏🙏🙏

[@vladislavkoinosov3600]

it would be great if the interface adapted to mobile devices. Like in MA2, sometimes it useful when you need to focus some fixtures that are far away from your console, and you can simply grab your smartphone connected to wi-fi router and do the job.

[@aloneone09]

Hello, thanks for these helpful tutorials. I would like to ask you if you could do a tutorial of connecting the MA3 console to a port node of any brand that is not the official MA port node (for example a cameo port node, showtec,...) Thank you so much

[@Event-Lighting]

Good idea for a video, i will consider that for a future video :-)

[@SvartAdamSolander]

Have you found a way to scale the web remote window? It's at 1x scale and it's way to big to be useful. I usually run my onPC at 0.75x scale to make it usable. I tried log in to the same session, but there was no change in the screen scale.

[@Event-Lighting]

I will try when i have the chance :-)

[@SvartAdamSolander]

@@Event-Lighting thanks! :)

[@edvardb-mh7jh]

Have you found?

[@szymonwieczorek2667]

wonderful material. helped me a lot. can you do something about ma3d???

[@Event-Lighting]

I have an older video on MA 3D kzbin.info/www/bejne/pqTTXoSYe7mHsMk I also have an older video on tuning the graphics in 3D here kzbin.info/www/bejne/hmrYmod4jLuYb7M And if you would like to know more about importing MVR shows into GrandMA3 you can check out this video kzbin.info/www/bejne/mKXOXqmDitOof5o :-)

[@andrescohan8071]

that was nice! there is any poibilityto talk about how to doit with a wi fi network. just in case i want to do web remote to an iapad or mobile. thank you. i belive tht i need i firouter conected to network switch

[@SvartAdamSolander]

I just tried it and it works perfectly from my MacOS onPC 1.8.8.2 setup to my browser in Linux over WiFi. Just see that you have your ip's in the correct range, as Tue said.

[@Event-Lighting]

I is the exact same process, just using your wi-fi adaptor to set IP. Don´t you it for show, only for pre programming. You will experience delay and instability on wi-fi. :-)

[@SvartAdamSolander]

A side note worth mentioning about Wi-Fi, is that, since a few versions ago (like last summer), you can't join a session over Wi-Fi. Like if you have a onPC node that's connected via ethernet to a router, and you're using the Wi-Fi on your computer and try to connect to the node. You have to use an ethernet interface on the computer for that.

[@Bingbanglightingdesinger]

With internet without internet?

[@Event-Lighting]

Without, this is for LAN, not WAN. :-)

[@Bingbanglightingdesinger]

❤❤❤❤❤❤

[@Event-Lighting]

:-)