This is exactly the video I was looking for very informative and concise thank you so much
@sixteenornumber
Sharpening the jaws a little made a huge difference.
@JH-sc7cs2 жыл бұрын
yep, grease everywhere from new cv boot fitted using just the plier style. thanks for sharing, will tighten it with the CV boot clamp tool which will crimp that dimple for final crush (VW)
@ntek27092 жыл бұрын
Much easier to just knock/slide the old clamps off their position - start with the larger one, knock it off, remove it, then slide the smaller one down to the thinner part of the axle and do same to it.
@d-s-ll23784 жыл бұрын
grind a wedge of snake head, expand the omega shape out, you can reuse the clampe several times, whatever Chinese made or non Chinese made clampe. use gental yet strong force, no cut.
@joejordan58795 жыл бұрын
The special pliers to put the clamp on is also used to take the clamp off.
@Hakkeholt3 жыл бұрын
I had the same tool, it snapped when I used it on original Oetiker clamps.
@timothytornado2650
Very good video!! Very helpful!!
@emiliog.44322 жыл бұрын
Thanks. I’d stick with oem Oeticker clamps. I agree with all of your assessments.
@jsmcguireIII2 жыл бұрын
these are designed to release by bending up the end after straightening the small flat key. Far easier than all this you are doing.