Repair a Garmin Edge Mount with a Trigo Replacement

[@al-du6lb]

when in doubt epoxy is always the way to go, amazing stuff

[@telsemtb9122]

Thanks for advice ,Just ordered kit from amazon ,I have the Garmin 830

[@MuckingMunt]

Good to know there's little kits like this available. 👍

[@faradhall5589]

Here is the problem. Once you apply the glue and have it set, you still risk the cpu falling off from the mount when you roll over rough terrain. While the replacement stayed attached, it somehow will break off from the garmin mount. This happened to me twice (two different garmin mounts). Lucky I had the garmin cord attached.

[@romlein]

Thank you for the excellent video! Will give this a try

[@billarduser5671]

1. Don't put one side of the clamp against the screen! Put a rigid material larger than the face of the garmin across it and clamp against that. 2. Put the screws back in for additional support.

[@ConstantRider]

Thanks for sharing.

[@alfredogguardiola]

thank you 🙏🙏

[@mansoursarkhoo196]

Still working well?

[@adambowie]

It is, although I have recently upgraded the device to the latest model, so I'm not using it now.

[@Colwray1]

Where did u get the kit?

[@adambowie]

I found it on eBay.

[@b-bikesinger]

I have the same issue, without a crash...Low built quality I guess...