Repair: OS FS 40 - New bearings

I removed the bearings from the engine (they were really ugly) and install new ones.
#repair #nitromotors

[@andresramirez-mp5zc]

Great video!. Are bearings with plastic retainers ok?

[@EnglishTurbines]

Did you scribe an x on the conrod and piston top before removal is the big question...?....🤔🤔😏😏😏🇬🇧

[@Ramztothaz]

Put the bearings in the freezer before installing. With frozen bearings and a heated bearing seat, they will basically fall right in.

[@VintageTechFan]

Tried that a few times. It works great with the big ones on the crankshaft, but the small camshaft bearings have so little heat capacity that they are back to room temperature basically immidiately after taking them out.

[@homienat3374]

What about valve clearance???? After rebuild????

[@twincam825]

At frame 19:49 looks like rod is install wrong bevel of rod should go towards crank.

[@homienat3374]

You wreck the engine

[@billjones3071]

Use a piece of wood to bang in the bearing, more heat and some oil

[@homienat3374]

You didnt event set timing ,totally wrong