2014 button housing has 4 plastic clips that hold it together, plus two metal clips not shown/seen here. Those metal clips must be pushed through/removed as well. Can't post pictures here, but once they came out it was a breeze, with the 4 plastic clips. While working with it the button fell off, but it has a keyway so can only snap back on one way. Same for reassembling button housing back into console. There's 3 keyways and the 4th is omitted, so it will only go back in one way. Excellent video, and helpful hints from others below in this comment section. Use the toothpick idea, SUCH a helpful hint. I had a set of jeweler's mini screwdrivers jammed in, and it was clumsy but worked.
@blue-ck9ns7 ай бұрын
I didn’t have any alcohol on hand, so just used the same method as you but water instead of alcohol and it still worked. The button on my golf r works like brand new again now
@dancumberland62157 ай бұрын
Yeah, I think they just need a decent clean to make better conatct
@danmoronel Жыл бұрын
10x a lot for the video. Works great now on my eGolf. It saved me from replacing a good button. It was really difficult to take the button out. You have to take a lot of parts out in order to take out the button without damage. Big minus for VW for serviceability.
@dancumberland6215 Жыл бұрын
Yeah, I was quoted a few hundred bucks for something that just needed a clean. Glad it helped!!!
@mislavkorda6538 Жыл бұрын
I have also problem on my egolf 2019, sometimes i need to push the button 10 times to start the car. Was it same for you? Have you fix it this way?
@dancumberland6215 Жыл бұрын
@@mislavkorda6538 Yeah Mislav, this is the issue I was facing. Hope the solution helps. 👍
@0-Will-0 Жыл бұрын
Another fixed button on an egolf. Lost the two clips inside the gear shifter housing but managed to recover one with a magnet on a stick. VW would have probably charged about 1-300 pounds for this. It's probably faulty by design as outside dirt is unlikely to reach that part. Just a case of lift up gear shifter housing from top, unclip start button by reaching thin flat head into clip and pulling, cleaning as per this video and putting back. About 10 mins work.
@piee6836 ай бұрын
@@0-Will-0hi,when you unclip the cable will the switch assembly just push up towards you with pressure up or do I have to reach in and squeeze the two silver clips at the same time whilst pushing up .thanks
@mikefrith4114Ай бұрын
Worked a treat, thanks. Used contact cleaner.
@justin47acr Жыл бұрын
Tq so much. Works perfectly now
@dancumberland6215 Жыл бұрын
You're welcome!
@RobertBrunoResearchDarknet Жыл бұрын
works flawlessly now, cheers!
@maxipulkinsk Жыл бұрын
Thank you! Worked perfectly for me. Since there are 4 clips on each side that must be lifted sort of simultaneously, I used a wooden toothpick, broken in pieces, to leave a small piece on each side which made it easier to keep them all lifted when pulling apart. Good luck and good project
@dancumberland6215 Жыл бұрын
Great idea. Thanks👍
@maquinte5 ай бұрын
Works for me, thanks BRO!
@dancumberland62155 ай бұрын
Good to hear!
@njmaxton4530 Жыл бұрын
Brilliant. Button works again.
@stephenbrown6647 ай бұрын
Just cleaned my 2017 Tiguan stop start too.. And yes.. Now works perfectly. Ridiculous you pay so much money for a vw and they continue to use a flawed stop start button...
@dancumberland62157 ай бұрын
Yes, service department wanted $350aud for replacement
@frvo11 ай бұрын
How did you take it off?
@dancumberland62157 ай бұрын
I've since sold the car but I remember i had to pop some clip out. Wasnt too difficult
@LuckySourlango8 күн бұрын
Absolute legend. Thank you
@bones4935Ай бұрын
thanks for posting this. Still useful after 2 years! Did this today and saved over A$300 the dealer wanted for a replacement installation. For others, there are two metal clips on the switch housing that also need be removed. A bit tricky but I eventually got them past the little tabs that hold them onto the switch body!