Wow and you did all that with one hand amazing job thanks bro.
@DaleKrishnaАй бұрын
Great video, got the dread display issue on my 07 civic! Wondering if you’d be able to assist? Obviously pay for your time
@EddieSpaghettiFN2 Жыл бұрын
Brilliant little info vid showing how to get it done without the “KZbinr” nonsense that some of the others do. Will get mine done when the weather picks up.
@bittripper353011 ай бұрын
That's how you do it after you've done it. It's actually much harder first time round
@MissionKid11 ай бұрын
First video where you actually zoom in on where you have to solder thank you gonna give it a go today
@saleemhoosen22365 ай бұрын
How did it go?
@lexzenis25442 жыл бұрын
yep...good result. well done. ive done a few of these now and i find you dont need to resolder at all. tip over the module so the pins face down (instead of up ) using a solder iron just heat up the base with the tip so the original solder will melt to gravitate down ( no more than 2mm ) and make good contact wit the pins. clean result , and no chance of shorting pins together.
@NewbieMechanic2 жыл бұрын
Yeah thanks! I've never done it before so my confidence was lacking.. I had to use the sucker tool to remove when i did too much solder. I improved as I went along. It works perfect now. So I would aay its a worthy result and I'll take it.
@jgm910 Жыл бұрын
When you say heat up the base mate, do you mean put the tip of the iron on the solder at the bottom of the pins?
@lexzenis2544 Жыл бұрын
@@jgm910 yes where the original solder is at the base that meets the cct board. But remember it will need to be done upside down to get the best result.
@akhilvarghese2498 Жыл бұрын
Thanks for this info mate. Sorry I know this sounds dumb but when you mean upside down, you mean top of head unit screen (when upright) down? So the opposite side of the solder joints from this video ?
@YZY_RAP9 ай бұрын
@@akhilvarghese2498 the man from the video placed the display on a table so the pins were facing up right? what @lexzenis2544 is saying is, you flip the display, so the pins are facing the ground. You then reheat the existing solder (not adding more solder) of each pin and, since the display is facing downwards, gravity will pull some solder to have it contact more of the pins, thus creating a better contact.
@wazza13utd Жыл бұрын
If only u lived local id av asked u to sort mine mate!
@AK313AK6 ай бұрын
I did this and it worked. But the next day it went back to how it was. Any ideas what i did wrong?
@NewbieMechanic6 ай бұрын
could be a different issue maybe try again
@Mooney762 жыл бұрын
Good job dude 👍 bet u was crapping it 😁 I know I wud b