Replace Hyundai Ignition Starter Switch Assembly (2006-2010 for Sonata Models)

[@lonniusmaximus3836]

Thank you for posting this! Super easy on my 2009 Sonata after watching this video. A couple of things I recommend for others: 1) Disconnect battery (in my case, because the switch was so bad I could no longer put it in "On" without starting the engine, plus it's just safer) and 2) disconnect the wiring harness before loosening the screw to make it easier to pull off and also for easier access to the screw. Thanks again for the video!

[@EdDoesTechEd]

Great! Thank you for the comment and the extra information Lonnius!

[@ItsLarry-in1jq]

I am having the same issue, where my ignition will start even with it just sitting in the on section in most positions, so this will be extremely helpful, thank you so much

[@usingtheirhypocracyagainst8636]

A very nice and straightforward explanation on how to perform this task without taking the car apart! Thanks

[@WandamianCrucifixplate]

This helped me in my Tucson. I didn't need to insert my key and switch to on. Literally just unscrewed it, unplugged it, and it was ready to go. Thanks

[@EdDoesTechEd]

Thanks for letting us know! Glad it helped. :)

[@usingtheirhypocracyagainst8636]

A very nice and straightforward explanation on how to perform this task without taking the car apart! But I would recommend you explain how you’re able to access the switch that easy because there’s a lot of stuff in the way including A cover that I think needs to be removed first, Thanks

[@toddthomas751]

You’re the bomb dude!!! Bought the part online and installed it in about 10 minutes…Thanks!

[@406rebrandingrichardegrimm6]

Great video. Adding multiple sources for parts was icing on the cake. Bless you!!!

[@EdDoesTechEd]

That's a great compliment! Glad you appreciated the content. 😊

[@spaceboy3101]

I have a 2009 santa fe. I'm not for certain this can be done without removing panels, but even if it can, unfortunately, my back will not tolerate getting down under there like that, so I think I'll have to pull panels regardless. Nice vid though. Looks easy enough once you get to it.

[@EdDoesTechEd]

Uh oh, hopefully you will have good luck in replacing it. I understand back issues, I have had them myself in the past. Thanks for the compliment. 😊

[@michellewilson7794]

U saved me so much bs. Thx ❤❤❤

[@eddiedrome8521]

Omg thank you so much for this video!!!!!

[@EdDoesTechEd]

You're welcome Eddie! I'm glad it helped you in some way! Subscribe and come back for more!

[@makeovermelanie3361]

I actually feel like I can do this after watching this vid. Don't ask me to. But I feel like I can.

[@EdDoesTechEd]

You can! Let me know if you need any assistance. :)

[@dirklentfer383]

Thank you worked perfectly 😎🕺😎🕺😎

[@CynthiaBowers-o8r]

How are you doing this laying upside down .

[@stgmaster]

Would this be the same process for a 2006 kia rio5?

[@lyndalgilliland3475]

What do you do if u cant turn the switch to "on" position cause u lost key??

[@jarvo7723]

Were you able to figure this out? I am running into this right now

[@brooklyn7941]

And I searched a thousand times to see if they have videos with this problem but nobody has this problem lol

[@EdDoesTechEd]

Still need assistance?

[@gentcollins]

Thanks for the help

[@EdDoesTechEd]

You're welcome, glad it helped.

[@donjrkocielko9295]

Thanks for video I may need to change mine on my 2007 sonata no start no sound. Did you have to use a memory saver to keep ECU from needing reprogrammed?

[@EdDoesTechEd]

Hi Don Jr Kocielko, Are you getting any lights at all when the keys turn? It's been almost a week since you coming at so hopefully you got it up and running. I did not go that far to use a memory saver, I didn't think changing the ignition switch would affect it that much. Maybe I should look into that next time, just to be safe. Thank you for your contribution.

[@EdDoesTechEd]

And you're very much welcome!

[@johnkopek7979]

I got one that after starting the starter continues to turn. It will stop when turning back on the key slightly. Guessing it needs this switch

[@tlpceqmf]

Did it fix your issue?

[@johnkopek7979]

@@tlpceqmf yes it did %100

[@dominiquemawaya3537]

How you did I have the same problem

[@zenamcfadden6178]

I purchased a new ignition switch, however, I did this because the key will not go into the "on" position. It is stuck in the lock, position and I can not turn it to the "on" position,

[@cindygarcia530]

You rule. Thanks!! So does KZbin!

[@EdDoesTechEd]

:'D Glad it helped!

[@BigBenny1]

Bro. Great video and I’m doing this right now. I am reinstalling the new switch and can’t seem to get it to snap in. Did you have an issue with it feeling like it’s not getting snug?

[@EdDoesTechEd]

Hey, I'm so sorry for replying so late. I wiggled it side to side and it snapped in when the hole matched up to the screw hole. I hope you got it in correctly!

[@daddiechente2847]

Having same issue

[@scootscoot97warlock90]

My 07 is on the steering column,. The key sticks, can't turn it unless you jiggle the key, then it will turn on and start.

[@jarvo7723]

My 09 sonata thinks that the key is still in the ignition even when I take it out. Car continues to beep at me and keeps the exterior lights on. Has anyone fixed that by changing the ignition switch?

[@isaiahfilmedthis9308]

Hello, I have a 07 sonata and my steering wheel is locked and the key will not turn in the ignition at all, I’ve tried simultaneously turning the wheel and key at the same time to unlock the wheel and start the car but i cannot, I’ve proceeded to just replacing the ignition switch etc however I cannot get the key in the ON position. Please help !!!

[@EdDoesTechEd]

Dang, that sounds like a steering column issue. When that is malfunctioning, you must try your best to move the steering wheel left or right, even a millimeter to loosen up the ignition switch enough for you to turn it with the key in it. I would suggest you doing more research, as I did, and found up three main causes. "While there are a variety of reasons your Hyundai Sonata key won't turn, the most common 3 are a binding steering column/lock, an ignition switch issue, or a problem with the ignition key." - repairpal.com The best of luck to you!

[@MichaelPatterson23]

What if I can’t get the switch to turn. Someone trying the steal the car now the key will not go all the into the ignition.

[@21111009198573]

Can you take out the ignition switch without putting it into the on position??

[@EdDoesTechEd]

I don't believe so as the internals won't allow it to release unless it is in position.

[@21111009198573]

@@EdDoesTechEd damn my key is stuck and it won’t let me turn it or remove it smh thanks for the quick response appreciate it

[@jarvo7723]

@@21111009198573 were you abe to figure this out? I cannot turn my key at all when it is in the ignition

[@stevemurphy1341]

Why can’t I get new to slide back in ?

[@bwill578]

How do you replace it if the key goes in the ignition but you can't turn it?

[@The_Mavs_Are_Bums]

I can't turn mine in my 09 sonata. Gotta figure it out

[@EdDoesTechEd]

That would have something to do with the steering wheel/column (I believe). Once you turn it in a certain angle (left or right) and hold it, it will break/loosen the wheel lock enabling you to to turn.

[@jarvo7723]

@@The_Mavs_Are_Bums Did you figure it out? My 09 sonata key wont turn. Have tried breaking the wheel lock by turning the wheel but no luck

[@The_Mavs_Are_Bums]

@@jarvo7723 my mechanic came to my house and he got it turned within a minute 🤣🤣🤣

[@The_Mavs_Are_Bums]

@@jarvo7723 he basically just forced it

[@Justin_Truax]

Was the original problem from you car randomly not cranking or starting? Mine does that sometiems. Hoping this easy fix will fix the problem

[@EdDoesTechEd]

Correct. To be honest, I'm still having that issue. I'm thinking now it is either the starter or the starter relay. Two different issues with two different and manual labor requirements. (haha)

[@Justin_Truax]

@@EdDoesTechEd haha mine turned out to be the starter! Have not had a problem since!

[@EdDoesTechEd]

@@Justin_Truax looks like I got some work to do! Thanks so much for your quick follow-up.

[@scamchan]

@@EdDoesTechEd I am sure this is the problem with my BORREGO it will randomly shut down like the key was turned to the off position all power is gone. I am sure it will get worse so I think this part maybe all that is required. rather than paying $140 or more for the entire unit.

[@EdDoesTechEd]

@@scamchan I'm gonna be looking at my spark plugs as well.

[@ClutchSpartan7]

So I did it and the lights don’t come on the dash anymore, has to be a faulty one right?

[@ClutchSpartan7]

Wasted time by not getting OEM :( ordering it now

[@ClutchSpartan7]

$260’later

[@awright1216]

I tried to do this repair myself and the new switch will not go all the way back in.

[@michaelclarke7182]

Hi. Good video. I'm wondering what the car was doing that made you change the swich.? Sometimes I go to start and it all the power cuts out. Battery cables are good. After a few back and forths... Car starts. But then I have to reset the radio stations. Any ideas ..? Thx.

[@EdDoesTechEd]

I would put the key into the ignition and turn and the power cut out. Seems to have been the same as you. The resetting of the radio stations seems to be more electrical related for sure. If I do the back and forth more times, it would reset as well.

[@mehandgriffiths3476]

I removed my switch without putting my key in the ignition. Why's that possible?

[@EdDoesTechEd]

😅

[@brooklyn7941]

I have a 2003 Elantra but I don’t see those clips it doesn’t even want to come out

[@EdDoesTechEd]

Well I guess it's less like a clip and more like a 'button', did you find it? :o

[@jupiterulloa1782]

I just did it didnt start but I unplug the battery for a min then it started whoop whoop

[@EdDoesTechEd]

Great to hear!

[@Khanflomah]

MY KEY WOULDNT NOT MOVE FROM LOCK. THIS IS WHAT I DID: Liquid WRENCH (not liquid NAILS, you gen z folk) sprayed in the lock slot, using the litte straw that comes with it, AND THEN waiting 2 days, and theb BACK FORTH BACK FORTH BACK FORTH, and it broke free. .. But I DID find the little area where you stick the allen wrench into (thats the L shaped tool you gen z people) And then it has to be a thin one. try different sizes. harbor freight, 7 dollars for a kit. I DID try to press the button and did... BUT MY key wouldnt leave the LOCK position. Maybe pressing that button and trying to jiggle it after 2 days of Liquid WRENCH sitting in it (which is better than wd40) and it gave way.

[@fathersonrepairdiy]

Thank you so much! This really helped and fixed my 2008 Hyundai Sonata also--here is how I fixed mine: kzbin.info/www/bejne/j3aYd2yrfpqJpsU I did mine without removing any panels too. Mine was making a loud grinding sound like when you try to start the engine when it is already running but only when the car was in park or neutral.

[@EdDoesTechEd]

Thanks for the comment and the share! DIY is the way to go!

[@Khanflomah]

please swing the frigging phone around a bit more... so I REALLY cant figure out the hell where you are under the wheel...

[@Jesus.Eternal]

Cannot get the white switch back in??? Does it have to be on?

[@EdDoesTechEd]

I believe I had to have the key turned to the 'ON' position. I'm sure you've got it by now though. haha